Measurement of Water Transport During Freezing in Mammalian Liver Tissue: Part II—The Use of Differential Scanning CalorimetrySource: Journal of Biomechanical Engineering:;1998:;volume( 120 ):;issue: 005::page 559DOI: 10.1115/1.2834745Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: There is currently a need for experimental techniques to assay the biophysical response (water transport or intracellular ice formation, IIF) during freezing in the cells of whole tissue slices. These data are important in understanding and optimizing biomedical applications of freezing, particularly in cryosurgery. This study presents a new technique using a Differential Scanning Calorimeter (DSC) to obtain dynamic and quantitative water transport data in whole tissue slices during freezing. Sprague-Dawley rat liver tissue was chosen as our model system. The DSC was used to monitor quantitatively the heat released by water transported from the unfrozen cell cytoplasm to the partially frozen vascular/extracellular space at 5°C/min. This technique was previously described for use in a single cell suspension system (Devireddy, et al. 1998). A model of water transport was fit to the DSC data using a nonlinear regression curve-fitting technique, which assumes that the rat liver tissue behaves as a two-compartment Krogh cylinder model. The biophysical parameters of water transport for rat liver tissue at 5°C/min were obtained as Lpg = 3.16 x 10−13 m3 /Ns (1.9 μm/min-atm), ELp = 265 kJ/mole (63.4 kcal/mole), respectively. These results compare favorably to water transport parameters in whole liver tissue reported in the first part of this study obtained using a freeze substitution (FS) microscopy technique (Pazhayannur and Bischof, 1997). The DSC technique is shown to be a fast, quantitative, and reproducible technique to measure dynamic water transport in tissue systems. However, there are several limitations to the DSC technique: (a) a priori knowledge that the biophysical response is in fact water transport, (b) the technique cannot be used due to machine limitations at cooling rates greater than 40°C/min, and (c) the tissue geometric dimensions (the Krogh model dimensions) and the osmotically inactive cell volumes Vb , must be determined by low-temperature microscopy techniques.
keyword(s): Freezing , Biological tissues , Differential scanning calorimetry , Liver , Water , Microscopy , Dimensions , Suspension systems , Cooling , Machinery , Cylinders , Ice , Low temperature , Biomedicine , Fittings AND Heat ,
|
Collections
Show full item record
contributor author | R. V. Devireddy | |
contributor author | J. C. Bischof | |
date accessioned | 2017-05-08T23:55:51Z | |
date available | 2017-05-08T23:55:51Z | |
date copyright | October, 1998 | |
date issued | 1998 | |
identifier issn | 0148-0731 | |
identifier other | JBENDY-26004#559_1.pdf | |
identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/120025 | |
description abstract | There is currently a need for experimental techniques to assay the biophysical response (water transport or intracellular ice formation, IIF) during freezing in the cells of whole tissue slices. These data are important in understanding and optimizing biomedical applications of freezing, particularly in cryosurgery. This study presents a new technique using a Differential Scanning Calorimeter (DSC) to obtain dynamic and quantitative water transport data in whole tissue slices during freezing. Sprague-Dawley rat liver tissue was chosen as our model system. The DSC was used to monitor quantitatively the heat released by water transported from the unfrozen cell cytoplasm to the partially frozen vascular/extracellular space at 5°C/min. This technique was previously described for use in a single cell suspension system (Devireddy, et al. 1998). A model of water transport was fit to the DSC data using a nonlinear regression curve-fitting technique, which assumes that the rat liver tissue behaves as a two-compartment Krogh cylinder model. The biophysical parameters of water transport for rat liver tissue at 5°C/min were obtained as Lpg = 3.16 x 10−13 m3 /Ns (1.9 μm/min-atm), ELp = 265 kJ/mole (63.4 kcal/mole), respectively. These results compare favorably to water transport parameters in whole liver tissue reported in the first part of this study obtained using a freeze substitution (FS) microscopy technique (Pazhayannur and Bischof, 1997). The DSC technique is shown to be a fast, quantitative, and reproducible technique to measure dynamic water transport in tissue systems. However, there are several limitations to the DSC technique: (a) a priori knowledge that the biophysical response is in fact water transport, (b) the technique cannot be used due to machine limitations at cooling rates greater than 40°C/min, and (c) the tissue geometric dimensions (the Krogh model dimensions) and the osmotically inactive cell volumes Vb , must be determined by low-temperature microscopy techniques. | |
publisher | The American Society of Mechanical Engineers (ASME) | |
title | Measurement of Water Transport During Freezing in Mammalian Liver Tissue: Part II—The Use of Differential Scanning Calorimetry | |
type | Journal Paper | |
journal volume | 120 | |
journal issue | 5 | |
journal title | Journal of Biomechanical Engineering | |
identifier doi | 10.1115/1.2834745 | |
journal fristpage | 559 | |
journal lastpage | 569 | |
identifier eissn | 1528-8951 | |
keywords | Freezing | |
keywords | Biological tissues | |
keywords | Differential scanning calorimetry | |
keywords | Liver | |
keywords | Water | |
keywords | Microscopy | |
keywords | Dimensions | |
keywords | Suspension systems | |
keywords | Cooling | |
keywords | Machinery | |
keywords | Cylinders | |
keywords | Ice | |
keywords | Low temperature | |
keywords | Biomedicine | |
keywords | Fittings AND Heat | |
tree | Journal of Biomechanical Engineering:;1998:;volume( 120 ):;issue: 005 | |
contenttype | Fulltext |