| contributor author | D. Ceglarek | |
| contributor author | J. Shi | |
| date accessioned | 2017-05-08T23:50:55Z | |
| date available | 2017-05-08T23:50:55Z | |
| date copyright | February, 1996 | |
| date issued | 1996 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27784#55_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/117340 | |
| description abstract | In this paper, a fault diagnostic method is proposed for autobody assembly fixtures. This method uses measurement data to detect and isolate dimensional faults of part caused by fixture. The proposed method includes a predetermined variation pattern model and a fault mapping procedure. The variation pattern model is based on CAD information about the fixture geometry and location of the measurement points. This fault mapping procedure combines Principal Component Analysis with pattern recognition approach. Simulations and one case study illustrate the proposed method. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Fixture Failure Diagnosis for Autobody Assembly Using Pattern Recognition | |
| type | Journal Paper | |
| journal volume | 118 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2803648 | |
| journal fristpage | 55 | |
| journal lastpage | 66 | |
| identifier eissn | 1528-8935 | |
| keywords | Manufacturing | |
| keywords | Jigs and fixtures | |
| keywords | Failure | |
| keywords | Patient diagnosis | |
| keywords | Pattern recognition | |
| keywords | Principal component analysis | |
| keywords | Geometry | |
| keywords | Computer-aided design AND Engineering simulation | |
| tree | Journal of Manufacturing Science and Engineering:;1996:;volume( 118 ):;issue: 001 | |
| contenttype | Fulltext | |