Effect of Abrasive Waterjet Parameters on Volume Removal Trends in Turning

Abstract

An experimental investigation was conducted to investigate the influence of abrasive waterjet parameters on the volume removal rate in abrasive waterjet turning. Abrasive mass flow rate, abrasive particle size, waterjet pressure, and orifice diameter were the principal variables that were investigated. Limited tests were also conducted with abrasive mixtures. The results show that the volume removal trends in abrasive waterjet turning are similar to those in linear cutting with abrasive waterjets. Increasing waterjet pressure, orifice diameter, and abrasive flow rate generally resulted in an increase in volume removal rate. However, the volume removal rate levels off either due to volume sweep rate limit or due to the abrasive waterjet limit. The results also suggest a potential for optimizing the abrasive flow rate and abrasive composition. The volume removal rate showed only a weak dependence on the abrasive particle size.