| contributor author | R. Nair | |
| contributor author | K. Danai | |
| contributor author | S. Malkin | |
| date accessioned | 2017-05-08T23:39:00Z | |
| date available | 2017-05-08T23:39:00Z | |
| date copyright | February, 1992 | |
| date issued | 1992 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27755#1_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/110550 | |
| description abstract | A method is presented for identifying the chip formation, plowing, and sliding forces in turning from force transients. For this purpose, a simple model is used which separates the cutting force into a sharp tool chip formation component and a residual component associated with both rubbing between the wear land and the workpiece and plowing at the cutting edge. Variations of the cross-sectional area of the cut during a transient are used to tune the model and estimate its parameters. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Turning Process Identification Through Force Transients | |
| type | Journal Paper | |
| journal volume | 114 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2899754 | |
| journal fristpage | 1 | |
| journal lastpage | 7 | |
| identifier eissn | 1528-8935 | |
| keywords | Force | |
| keywords | Turning | |
| keywords | Cutting AND Wear | |
| tree | Journal of Manufacturing Science and Engineering:;1992:;volume( 114 ):;issue: 001 | |
| contenttype | Fulltext | |