Show simple item record

contributor authorB. D. Hsu
date accessioned2017-05-08T23:38:22Z
date available2017-05-08T23:38:22Z
date copyrightJuly, 1992
date issued1992
identifier issn1528-8919
identifier otherJETPEZ-26705#502_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/110199
description abstractThe U.S. Department of Energy is sponsoring a General Electric Company development program for using coal-water slurry (CWS) to power a diesel engine and to test it in a locomotive. The first locomotive system test was successfully completed in 1991 on GE/TS test track. The first-phase coal-fueled 12-cylinder diesel engine used in the locomotive test employed a modified positive displacement fuel injection system and developed 2500 hp in the engine laboratory. The final phase all electric controlled fuel injection equipment (FIE) diesel engine has completed individual component development phases. Combustion research evaluated a broad range of CWS fuels with different source coals, particle sizes, and ash contents. The electronic controlled FIE single cylinder test engine yielded 99.5 percent combustion efficiency. Envelop filters and copper oxide sorbent have been chosen to clean up the engine emissions after extensive evaluation of various hot gas cleaning methods. The projected removal rate of particulate is 99.5 percent and that of SO2 is 90 percent. Over ten diamond insert injector nozzles performed well on the test engines. A bench test of one nozzle has been run for over 500 engine equivalent hours without significant wear. Tungsten carbide (WC) coated piston rings and cylinder liners were identified to be effective in overcoming power assembly wear. A matrix of WC spray parameters were investigated, and the best process was used to apply coatings onto full scale rings and liners. These and other test parts are currently running in two coal fuel operated cylinders on a converted eight-cylinder endurance test engine. All of these developed technologies will be applied onto the second phase engine and be used in the final phase locomotive test. An economic analysis was also completed on a concept locomotive design. Additional equipment cost and the level of diesel fuel price to repay the investment were analyzed. Thus the economic environment for the commercialization of the modern coal fueled locomotive is defined.
publisherThe American Society of Mechanical Engineers (ASME)
titleCoal-Fueled Diesel Engine Development Update at GE Transportation Systems
typeJournal Paper
journal volume114
journal issue3
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.2906617
journal fristpage502
journal lastpage508
identifier eissn0742-4795
keywordsCoal
keywordsTransportation systems
keywordsDiesel engines
keywordsEngines
keywordsLocomotives
keywordsCylinders
keywordsFuels
keywordsParticulate matter
keywordsWear
keywordsCombustion
keywordsNozzles
keywordsSlurries
keywordsSprays
keywordsTungsten
keywordsWater
keywordsEmissions
keywordsDisplacement
keywordsEconomic analysis
keywordsFilters
keywordsCopper
keywordsCoatings
keywordsManufacturing
keywordsPiston rings
keywordsSorbents
keywordsCylinder tests (Concrete)
keywordsDesign
keywordsEjectors
keywordsDiamonds AND Diesel
treeJournal of Engineering for Gas Turbines and Power:;1992:;volume( 114 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record