| contributor author | O. M. Ettouney | |
| contributor author | K. A. Stelson | |
| date accessioned | 2017-05-08T23:33:03Z | |
| date available | 2017-05-08T23:33:03Z | |
| date copyright | August, 1990 | |
| date issued | 1990 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27744#267_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/107163 | |
| description abstract | This paper addresses an approach to calculate the friction coefficient during nonuniform compression of cylinders. The approach combines new friction-calibration curves (prepared using the finite-element analysis) that relate friction to workpiece shape and the foldover model from Part I. Foldover in upsetting is used in the same way that the change in internal diameter is used in the ring test to determine friction. However, the new approach has the advantage that measurements are taken directly from the workpiece. Comparisons of friction values calculated from the ring test and the new approach showed good agreement. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | An Approximate Model to Calculate Foldover and Strains During Cold Upsetting of Cylinders Part II: Use of the Foldover Model to Estimate Friction | |
| type | Journal Paper | |
| journal volume | 112 | |
| journal issue | 3 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2899585 | |
| journal fristpage | 267 | |
| journal lastpage | 271 | |
| identifier eissn | 1528-8935 | |
| keywords | Friction | |
| keywords | Cylinders | |
| keywords | Shapes | |
| keywords | Measurement | |
| keywords | Finite element analysis | |
| keywords | Calibration AND Compression | |
| tree | Journal of Manufacturing Science and Engineering:;1990:;volume( 112 ):;issue: 003 | |
| contenttype | Fulltext | |