| contributor author | W. H. Greenwood | |
| contributor author | K. W. Chase | |
| date accessioned | 2017-05-08T23:27:34Z | |
| date available | 2017-05-08T23:27:34Z | |
| date copyright | August, 1988 | |
| date issued | 1988 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27732#232_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/104111 | |
| description abstract | When designers assign tolerances on engineering drawings, they have a significant influence on the resulting cost and producibility of manufactured products. A rational basis for assigning tolerances involves constructing mathematical models of tolerance accumulation in assemblies of parts. However, tolerance stacks in two or three-dimensional problems or other nonlinear assembly functions may distort the resultant assembly tolerances, altering the range and symmetry. An iterative method is described for adjusting the nominal dimensions of the component parts such that the specified assembly limits are not violated. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Worst Case Tolerance Analysis with Nonlinear Problems | |
| type | Journal Paper | |
| journal volume | 110 | |
| journal issue | 3 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3187874 | |
| journal fristpage | 232 | |
| journal lastpage | 235 | |
| identifier eissn | 1528-8935 | |
| keywords | Dimensions | |
| keywords | Manufacturing | |
| keywords | Engineering drawings | |
| keywords | Functions | |
| keywords | Iterative methods AND Tolerance analysis | |
| tree | Journal of Manufacturing Science and Engineering:;1988:;volume( 110 ):;issue: 003 | |
| contenttype | Fulltext | |