Search
CSV
RISFundamental Issues and Technical Problems About Pulsating Heat Pipes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Since their introduction in the early 1990s, pulsating heat pipes (PHPs) have received a lot of attention due to their obvious advantages such as their geometrical simplicity, and their potential for high-heat flux ...
Motion Artifact Reduction Algorithm in Wearable Healthcare System1
Publisher: The American Society of Mechanical Engineers (ASME)
On the Effect of Side Clearance in the Vaned Diffuser of a Centrifugal Compressor
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Environmental and regulatory pressures have prompted original equipment manufacturers (OEMs) to explore highly boosted internal combustion (IC) engines as a means to minimize toxic air pollutants and meet strict legislative ...
Storm Surges in the Region of Western Alaska
Publisher: American Meteorological Society
Abstract: Within the period of the historical record there have been several occurrences of extensive damage from storm-surge-related coastal flooding in the region of Nome, Alaska. The most recent of these events, although by no ...
Characterizing the Influence of Impeller Exit Recirculation on Centrifugal Compressor Work Input
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Impeller recirculation is a loss which has long been considered in one-dimensional (1D) modeling; however, the full extent of its impact on stage performance has not been analyzed. Recirculation has traditionally been ...
A Three-Zone Modeling Approach for Centrifugal Compressor Slip Factor Prediction
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Accurate estimation of slip factor is of paramount importance to ensure centrifugal compressor work input is adequately predicted during the preliminary design process. However, variations in the flow field at impeller ...
Real-Time Adaptive Observation Guidance Using Singular Vectors for Typhoon Jangmi (200815) in T-PARC 2008
Publisher: American Meteorological Society
Abstract: n this study, structures of real-time adaptive observation guidance provided by Yonsei University (YSU) in South Korea during The Observing System Research and Predictability Experiment (THORPEX)-Pacific Asian Regional ...
Evaluating the Use of Leaned Stator Vanes to Produce a Non-Uniform Flow Distribution Across the Inlet Span of a Mixed Flow Turbine Rotor
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Current trends in the automotive industry have placed an increased emphasis on downsized turbocharged engines for passenger vehicles. The turbocharger is increasingly relied upon to improve power output across a wide range ...
Numerical Investigation of Nanofluid as a Coolant in a Prismatic Battery for Thermal Management Systems
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This study delves into the realm of numerical investigation of the heat transfer performance of nanofluids as coolants for prismatic batteries. Nanofluids are being employed in battery cooling systems to enhance overall ...
Investigation of a Novel Turbine Housing to Produce a Nonuniform Spanwise Flow Field at the Inlet to a Mixed Flow Turbine and Provide Variable Geometry Capabilities
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Automotive engine downsizing has placed an increased focus on the ability of the turbocharger to provide adequate boost levels across the full engine operating range. To achieve the desired levels of turbocharger performance, ...