| contributor author | Rafał Dalewski | |
| contributor author | Konrad Gumowski | |
| contributor author | Tomasz Barczak | |
| contributor author | Jan Godek | |
| date accessioned | 2017-12-30T13:03:08Z | |
| date available | 2017-12-30T13:03:08Z | |
| date issued | 2017 | |
| identifier other | %28ASCE%29AS.1943-5525.0000776.pdf | |
| identifier uri | http://138.201.223.254:8080/yetl1/handle/yetl/4245051 | |
| description abstract | In this article, an analysis of a manufacturing process for small aerodynamic elements is presented. Two manufacturing methods—selective laser sintering (SLS) and fused deposition modeling (FDM)—were investigated. For both, the same additional surface-processing method was applied to obtain the desired surface properties. The geometry of the manufactured elements at different stages of surface processing was observed and tested with a profilometer and a scanner to quantify deviations. Process deviations were classified and quantified. The aerodynamic performance and practical application of the models and methods are discussed in this article. | |
| publisher | American Society of Civil Engineers | |
| title | Analysis of an Additive Manufacturing Process for an Unmanned Aerial Vehicle | |
| type | Journal Paper | |
| journal volume | 30 | |
| journal issue | 6 | |
| journal title | Journal of Aerospace Engineering | |
| identifier doi | 10.1061/(ASCE)AS.1943-5525.0000776 | |
| page | 04017070 | |
| tree | Journal of Aerospace Engineering:;2017:;Volume ( 030 ):;issue: 006 | |
| contenttype | Fulltext | |