Show simple item record

contributor authorRafał Dalewski
contributor authorKonrad Gumowski
contributor authorTomasz Barczak
contributor authorJan Godek
date accessioned2017-12-30T13:03:08Z
date available2017-12-30T13:03:08Z
date issued2017
identifier other%28ASCE%29AS.1943-5525.0000776.pdf
identifier urihttp://138.201.223.254:8080/yetl1/handle/yetl/4245051
description abstractIn this article, an analysis of a manufacturing process for small aerodynamic elements is presented. Two manufacturing methods—selective laser sintering (SLS) and fused deposition modeling (FDM)—were investigated. For both, the same additional surface-processing method was applied to obtain the desired surface properties. The geometry of the manufactured elements at different stages of surface processing was observed and tested with a profilometer and a scanner to quantify deviations. Process deviations were classified and quantified. The aerodynamic performance and practical application of the models and methods are discussed in this article.
publisherAmerican Society of Civil Engineers
titleAnalysis of an Additive Manufacturing Process for an Unmanned Aerial Vehicle
typeJournal Paper
journal volume30
journal issue6
journal titleJournal of Aerospace Engineering
identifier doi10.1061/(ASCE)AS.1943-5525.0000776
page04017070
treeJournal of Aerospace Engineering:;2017:;Volume ( 030 ):;issue: 006
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record