Journal of Fluids Engineering: Recent submissions
Now showing items 8321-8340 of 9024
-
Fluid Dynamic Excitation of Centrifugal Compressor Rotor Vibrations
(The American Society of Mechanical Engineers (ASME), 1978)A mechanism by which compressor rotor lateral vibration perturbs the mass flow-rate, the velocity and the pressure distributions within impeller passages is postulated. Such a perturbation will ... -
Frictional Moment of Flow Between Two Concentric Spheres, One of Which Rotates
(The American Society of Mechanical Engineers (ASME), 1978)Frictional moment is investigated experimentally for the flow between a rotating inner sphere and a stationary outer one, and for the flow between a rotating outer sphere and a stationary inner ... -
Discussion: “The Calibration of Preston Tubes in Transpired Turbulent Boundary Layers” (Depooter, K., Brundrett, E., and Strong, A. B., 1978, ASME J. Fluids Eng., 100, pp. 10–15)
(The American Society of Mechanical Engineers (ASME), 1978) -
Discussion: “An Experimental Study of Three-Dimensional Characteristics of Propeller Wakes Under Stalling Conditions” (Favier, D., Rebont, J., and Maresca, C., 1977, ASME J. Fluids Eng., 99, pp. 745–752)
(The American Society of Mechanical Engineers (ASME), 1978) -
Discussion: “Turbulence Measurements in Boundary Layers Along Mildly Curved Surfaces” (Shivaprasad, B. G., and Ramaprian, B. R., 1978, ASME J. Fluids Eng., 100, pp. 37–45)
(The American Society of Mechanical Engineers (ASME), 1978) -
Discussion: “Conditions for a Pipe to Run Full When Discharging Liquid Into a Space Filled With Gas” (Wallis, G. B., Crowley, C. J., and Hagi, Y., 1977, ASME J. Fluids Eng., 99, pp. 405–413)
(The American Society of Mechanical Engineers (ASME), 1978) -
The Calibration of Preston Tubes in Transpired Turbulent Boundary Layers
(The American Society of Mechanical Engineers (ASME), 1978)The Preston tube calibration of Patel is reproduced for zero pressure gradient and zero mass transfer turbulent flows, by momentum balance and by direct measurement using a floating element ... -
Discussion: “Lift on a Rotating Porous Cylinder” (So, R. M. C., 1977, ASME J. Fluids Eng., 99, pp. 753–757)
(The American Society of Mechanical Engineers (ASME), 1978) -
Nonlinear Viscosity Effects in Slider Bearing Lubrication
(The American Society of Mechanical Engineers (ASME), 1962)The relationship between stress and rate of strain for a non-Newtonian fluid with pseudoplastic behavior is assumed to be a cubic power series. Under this assumption a solution of the slider ... -
Discussion: “Numerical Modelling of Unsteady, Separated Viscous Flow” (Giaquinta, A. R., 1977, ASME J. Fluids Eng., 99, pp. 657–665)
(The American Society of Mechanical Engineers (ASME), 1978) -
Periodic Discontinuities in the Acceleration of Spheres in Free Flight
(The American Society of Mechanical Engineers (ASME), 1978)The trajectories of unrestrained spheres being accelerated from rest behind a normal shock wave in a shock tube have been recorded by high-speed stroboscopic photography, and precise measurements ... -
Discussion: “Derivation of Turbulent Transport Parameters in Isotropic Turbulence” (Abdel-Gayed, R. G., and Bradley, D., 1977, ASME J. Fluids Eng., 99, pp. 732–736)
(The American Society of Mechanical Engineers (ASME), 1978) -
Discussion: “Instability of Elastically Suspended Tanter-Gate System Caused By Surface Waves on the Reservoir of a Dam” (Ishii, N., Omaichi, K., and Hirase, A., 1977, ASME J. Fluids Eng., 99, pp. 699–708)
(The American Society of Mechanical Engineers (ASME), 1978) -
A Yaw-Insensitive Static Pressure Probe
(The American Society of Mechanical Engineers (ASME), 1978)This paper reviews the development and testing of a static pressure probe which is relatively insensitive to yaw angle. The probe averages the pressure along an equatorial line on a sphere ... -
Boundary Layer Calculation for Analysis and Design
(The American Society of Mechanical Engineers (ASME), 1978)A simple, semiempirical method for calculating the laminar, transition, and turbulent boundary layer with arbitrary free stream pressure gradient is developed. Good correlation is obtained with ... -
The Flapwing, A Unique Fluid Machine Element
(The American Society of Mechanical Engineers (ASME), 1978)A flow engine element is described which converts the oscillations of a flapwing, that is mounted on a crankshaft, into rotary energy. A self-starting twin model of this energy flux converter ... -
Analytic Derivation of Static Pressure Distribution in Fully Developed Helical Flows
(The American Society of Mechanical Engineers (ASME), 1978) -
Flow Induced Vibrations of a Hydraulic Valve and Their Elimination
(The American Society of Mechanical Engineers (ASME), 1978)The flow induced vibrations of a check valve with a spring damper to prevent slamming have been studied experimentally. Both prototype and two-dimensional model experiments were conducted to ... -
Liquid Jet Impingement Normal to a Disk in Zero Gravity
(The American Society of Mechanical Engineers (ASME), 1978)An experimental and analytical investigation was conducted to determine the free surface shapes of circular jets impinging normal to sharp-edged disks in zero gravity. Experiments conducted in a ... -
Review—Self-Sustaining Oscillations of Flow Past Cavities
(The American Society of Mechanical Engineers (ASME), 1978)Unstable flow past cavities is grouped into fluid-dynamic, fluid-resonant, and fluid-elastic categories. Fluid-dynamic oscillations are attributable to instability of the cavity shear layer and are ...