Journal of Aerospace Engineering: Recent submissions
Now showing items 461-480 of 2488
-
Mechanical and Fatigue Behavior of Resistance Spot Welded Dual-Phase and Twinning-Induced Plasticity Steel Joints
(ASCE, 2022-01-24)The new generation high-strength steel sheet has been widely used to reduce the vehicle weight. In this study, the mechanical, metallurgical, and fatigue behavior of the resistance spot-welded joints of high strength steel ... -
Numerical Study on the Effect of Vortex Generators on S-Shaped Intake in Propeller Slipstream
(ASCE, 2022-02-14)In turboprop engines, the lip of the S-shaped intake is behind the propeller rotation plane, so the complex slipstream flowfield has a strong impact on the flowfield in the S-shaped intake and affects engine performance. ... -
Enhancing Flight Envelope for a Nonlinear Aeroelastic Wing-Section Using Adaptive Fuzzy Sliding Mode Control Law
(ASCE, 2022-01-27)This paper presents an adaptive fuzzy sliding mode controller (AFSMC) for the control of a nonlinear aeroelastic wing section. The proposed controller estimates both the model dynamics of the system and the switching control ... -
Flow Over Flat and Curved Plates: A Flow Visualization Study
(ASCE, 2022-04-11)Visualization experiments are conducted in a water channel to investigate the wake vortex characteristics of a flat plate and convex and concave curved plates. Three parameters—vortex size (Sv), vortex length (Lv), and ... -
Maneuver Optimization for Simultaneous Airspeed Calibration and Wind Estimation
(ASCE, 2022-01-11)The purpose of this work is to optimize systematically the maneuver required to identify the wind and calibrate the airspeed sensor of a subsonic aircraft using a global positioning system method. The optimization is based ... -
Nacelle Inlet Optimization at High Angles of Attack Based on the Ensemble Indicator Method
(ASCE, 2022-01-03)Inlet separation is one of the primary sources of distortion at fan entrances. High angles of attack (AOAs) are the critical cause of inlet separation. Optimizing the inlet shape to increase the separation angle is of great ... -
Coverage Analysis of Remote Sensing Satellites in Concurrent Design Facility
(ASCE, 2022-01-20)This paper presents a new, accurate, and fast methodology, remote sensing satellites coverage analysis (RSS-CA) for determining the coverage area of Earth observation satellites in concurrent design facilities (CDFs) devoted ... -
Study on Fretting Wear of Contact Interface of Curvic Coupling for Circumferential Rod Combined Rotor
(ASCE, 2022-01-24)Fretting wear is a general surface damage form in tightly connected structures. Aimed at the curvic coupling of the disks in combined rotor gas turbine, using the finite-element method and Archard wear theory, the effects ... -
Implementation of UAV Smooth Path Planning by Improved Parallel Genetic Algorithm on Controller Area Network
(ASCE, 2021-12-28)Unmanned aerial vehicle (UAV) path planning is an essential branch in UAVs research. This paper presents the hardware implementation of the UAV path planning problem using an improved parallel genetic algorithm (GA) in a ... -
Evaluation of Bosch Process–Sourced Carbon in Low-Carbon Steel and Gray Iron Casting for Martian Surface Manufacturing
(ASCE, 2021-12-21)As research continues for the first crewed missions to and the eventual colonization of Mars, the need for materials for construction of structural and mechanical components remains paramount. The use of in situ resource ... -
Nonlinear Control of Aircraft Flight Dynamics Using Integrator-Backstepping Design Method
(ASCE, 2022-01-05)This paper investigated a nonlinear control algorithm for flight dynamics of aircraft using an integrator backstepping–based design. The paper focused on two points. Firstly, a systematic procedure was presented for ... -
Slit Effectiveness Analysis on the Lift Fluctuation Caused by Low-Speed Laminar Flow over a Circular Cylinder
(ASCE, 2021-12-30)Low-speed laminar flow over a slotted circular cylinder was numerically studied to investigate the slit effectiveness on the vortex shedding suppression and also determine the suppression mechanism physically. The base ... -
Effect of Rubber Strain Rate on Performance of Aircraft Tire
(ASCE, 2022-01-10)An aircraft tire is a kind of rubber product with a complex structure. When subjected to impact load, the mechanical properties of rubber material on strain history and strain rate cannot be ignored. According to the ... -
Aeroelastic Damping Estimation for a Flexible High-Aspect-Ratio Wing
(ASCE, 2021-12-21)Estimation of aeroelastic damping for a very flexible high-aspect-ratio wing using wind-tunnel test data is presented in this work through the comparison of four different methods: half-power, half-quadratic gain, an adapted ... -
Trajectory Planning of Free-Floating Space Robot Based on Dual-Mode Switching
(ASCE, 2022-02-25)For trajectory planning problem with multiconstraints of free-floating space robots (FFSR), the optimal solution may be unavailable due to strict constraints. In order to avoid identify a solution and obtain an executable ... -
A Novel Collision-Free Detumbling Strategy for a Space Robot with a 7-DOF Manipulator in Postcapturing Phase
(ASCE, 2022-01-25)Space robots are widely used for on-orbit capturing. After capturing a rotational non-cooperative target, its momentums produce unpredictable movements for the resultant space robot-target compound system. In order to ... -
Anti-Unwinding Immersion and Invariance Adaptive Attitude Control of Rigid Spacecraft with Inertia Uncertainties
(ASCE, 2021-12-29)A modular anti-unwinding dynamic scaling–based immersion and invariance (I&I) adaptive control is devised for rigid spacecraft attitude with inertia uncertainties. It is shown that the parametric regressor matrix cannot ... -
On the Reductions of Airfoil Broadband Noise through Sinusoidal Trailing-Edge Serrations
(ASCE, 2022-01-10)The present study investigates the efficacy of sinusoidal trailing-edge (TE) serrations as a passive means for the reductions of airfoil broadband noise, theoretically and experimentally. Comprehensive parametric studies ... -
Predictive Model of Dynamic Mechanical Properties of VE Damper Based on Acrylic Rubber–Graphene Oxide Composites Considering Aging Damage
(ASCE, 2021-11-27)Because shock absorbers are an important component of high-rise buildings, it is essential to be able to detect damage to them. Viscoelastic (VE) dampers, as a common shock absorber, directly affect the safety and reliability ... -
Sliding Mode Lateral Guidance and Control of Finless Airship
(ASCE, 2021-11-27)The path following a finless airship is presented in this paper using a nonunified sliding mode-based lateral guidance and control framework. The outer-guidance loop relies on the airship’s kinematics, and the designed ...