Journal of Aerospace Engineering: Recent submissions
Now showing items 441-460 of 2488
-
An Integrated Tracking Control Approach Based on Reinforcement Learning for a Continuum Robot in Space Capture Missions
(ASCE, 2022/06/02)In this paper, an integrated tracking control approach was developed for a continuum robot in space capture missions. For the configuration of a three-module cable-driven continuum robot, the nonlinear dynamics equations ... -
Implementing Optimization Methods in the Design of IsoTruss Structures in Uniaxial Compression
(ASCE, 2022/05/30)This study examines two techniques to optimize the design of lightweight composite IsoTruss columns subject to uniaxial compression: gradient-based (interior-point with algorithmic differentiation and Latin hypercube ... -
Experimental and Numerical Analysis of Pressure-Effect Threat Model Based on SPH Method
(ASCE, 2022-02-26)Based on smooth particle hydrodynamics (SPH) method, a model of impact response of tire burst pressure effect model on rear wall panel of landing gear cabin was established. The model was tested for air pressure distribution ... -
Nonlinear Control of a Novel Class of Tilt-Rotor Quadcopters Using Sliding Mode Method: Theory and Hardware Implementation
(ASCE, 2022-02-24)This paper proposes a sliding mode controller for a novel kind of quadcopter called tilt-rotor quadcopter. The controller is modeled in SIMULINK and implemented on a Pixhawk 2 flight controller board. First, this paper ... -
Minimization of Cable-Net Reflector Shape Error by Target-Approaching and Procedural-Learning Method
(ASCE, 2022-02-10)Cable length adjustment is a critical step to minimize the shape error of cable-net reflectors. The adjustment requires tedious repetitive work, but the surface accuracy is often unsatisfactory because of inevitable operating ... -
Dynamic Crack Propagation along Elastic Interfaces in Double Cantilever Beams under High Loading Rates
(ASCE, 2022-03-16)The dynamic mode-I energy release rate of cracks propagating along elastic interfaces in double cantilever beams under high loading rates is derived analytically for the first time by accounting for structural vibration, ... -
Modeling of Biaxial Compression Behavior of Carbon Fiber–Reinforced Composite after Low-Velocity Impact
(ASCE, 2022-03-09)This study presents a finite-element (FE) model considering intralaminar damage and interlaminar delamination to predict the biaxial compression behavior of carbon fiber–reinforced composites (CFRCs) with low-velocity ... -
Response of Graded Miura-Ori Metamaterials to Quasi-Static and Dynamic In-Plane Compression
(ASCE, 2022-03-24)The non-unique relationship between the density and quasi-static strength of Miura-ori metamaterials was explored for graded materials with respect to quasi-static and dynamic in-plane compression. A lower bound estimate ... -
Characterization of Nonlinear Birchwood Model with Strain Rate Effect
(ASCE, 2022-03-16)As a common engineering material, wood has been widely used and researched for a long time. The dynamic characteristic of green wood in living trees is very critical in the impact analysis; however, the research on it is ... -
Global Stability and Sensitivity Investigation of Nonlinear Dynamics of Compressor Diffuser with Numerical Volute Approach
(ASCE, 2022-02-14)Although the increase of the width ratio of a radial diffuser generally leads to a more unstable condition, the effect of volute was seldom considered in previous experimental and numerical studies because of the mismatching ... -
Experimental and Numerical Investigations of Modified Synthetic Jet Actuator for Active Flow Control
(ASCE, 2022-02-28)This paper presents the results of experimental and numerical investigations on synthetic jet actuators with various arrangements. First, an actuator with one membrane in the cavity is a standard, reference arrangement; ... -
The Effect of Unsteady Flapping Motion on the Aerodynamic Performance of Bio-Inspired Alula
(ASCE, 2022-02-24)Avian flight has inspired scientists and engineers for a long time. Flapping-wing micro air vehicle (FMAV) is a kind of air vehicle mimicking the avian flapping flight that has achieved great success in this century. ... -
Study of Aluminum Alloy 7075-T6 under Ultrasonic Fatigue Loading
(ASCE, 2022-03-18)A detailed ultrasonic cycle fatigue study has been presented for aluminum alloy 7075-T6 (AA7075-T6) under fully reversed tension-compression loading to investigate the geometric sensitivity, frequency effects, size effects, ... -
MDAO Method and Optimum Designs of Hybrid-Electric Civil Airliners
(ASCE, 2022-03-17)Hybrid-electric civil airliners (HECAs) are considered the forerunner of the solution of relieving aviation emissions. This paper presents a multidisciplinary design analysis and optimization (MDAO) framework named GENUS, ... -
Prediction of Maximum Lift Coefficient of Box-Wing Aircraft through the Combination of an Analytical Adaptation of the DATCOM Method and Vortex-Lattice Simulations
(ASCE, 2022-03-10)The present paper concerns the introduction of a mixed analytical-numerical method for the estimation of the maximum lift coefficient of box-wing aircraft in unflapped configuration. The analytical aspect is related to the ... -
Design and Calibration of a Torsion Pendulum for Micronewton-Class Spacecraft Thrusters
(ASCE, 2022-02-28)The development and calibration of a micronewton space thruster test stand is described. The test stand uses a torsion pendulum-type design. A calibration system consisting of a rarefied-flow, gas-dynamic thruster was used ... -
Novel Computational Method for Evaluation of the Effects of Random Rib Assemblage Errors on the Performance of Umbrella Antennas
(ASCE, 2022-01-31)To reveal the effects of random rib assemblage errors caused by misalignment on the performance of umbrella antennas, a novel computational method is proposed to evaluate the effects of random rib assemblage errors on ... -
Dynamics of Tethered-Coulomb Formation for Debris Deorbiting in Geosynchronous Orbit
(ASCE, 2022-02-22)In order to reduce the population of space debris in geosynchronous orbit, a tethered-Coulomb formation (TCF) is proposed that consists of a space tug and a cluster of charged debris connected by elastic massless tethers. ... -
Guided Wave Excitation and Sensing in Constant Irregular Cross Section Structures with the Semianalytical Finite-Element Method
(ASCE, 2022-02-25)Guided waves play an important role in practical structural health monitoring (SHM) systems. Due to the complexity of irregular cross sections, there has been little research on guided wave modal control done using excitation ... -
Surface Roughness Effects on Unsteady Transition Property over a Pitching Airfoil
(ASCE, 2022-01-31)The characteristics of unsteady boundary-layer transition on a small-amplitude pitching NACA0012 airfoil are investigated using the γ−Reθt¯−Ar transition model, which consists of the γ−Reθt¯ transition model and the roughness ...