| contributor author | E. J. Ewertz | |
| contributor author | E. G. Thomsen | |
| contributor author | F. D. Negroni | |
| date accessioned | 2017-05-08T23:20:39Z | |
| date available | 2017-05-08T23:20:39Z | |
| date copyright | August, 1985 | |
| date issued | 1985 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27714#261_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/100098 | |
| description abstract | Two anisotropic copper rods 12.5 mm in diameter produced in continuous casting operations at different casting speeds were successfully drawn as cast at various reductions in area up to 60 percent. It was found also that hot rolled commercial copper showed anisotropy in shear. With the aid of Hill’s theory of anisotropy it was possible to utilize Avitzur’s model of drawing for the prediction of drawing stresses achieving moderate success. The effect of redundant deformation theoretically computed is discussed. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Influence of Anisotropy on the Drawability of Continuously Cast Copper | |
| type | Journal Paper | |
| journal volume | 107 | |
| journal issue | 3 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3185996 | |
| journal fristpage | 261 | |
| journal lastpage | 265 | |
| identifier eissn | 1528-8935 | |
| keywords | Copper | |
| keywords | Anisotropy | |
| keywords | Casting | |
| keywords | Stress | |
| keywords | Shear (Mechanics) | |
| keywords | Rods AND Deformation | |
| tree | Journal of Manufacturing Science and Engineering:;1985:;volume( 107 ):;issue: 003 | |
| contenttype | Fulltext | |