Show simple item record

dc.contributor.authorR. F. Scrutton
dc.contributor.authorJ. G. Lenard
dc.date.accessioned2017-05-08T23:13:30Z
dc.date.available2017-05-08T23:13:30Z
dc.date.copyrightJanuary, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26885#53_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95914
dc.description.abstractThin strip specimens were reduced to foil by passing them repeatedly between the rolls of a two-high mill at low speeds. Narrow specimens were tested to avoid complications caused by roll bending. Factors governing the rate of reduction were examined, these being roll preload value and roll surface finish for low carbon strips as well as material strength, hardness, and anisotropy for aluminum and copper. No minimum thickness was found for the steel specimens; for aluminum and copper limiting thickness values were obtained based on the onset of edge cracking and longitudinal fracture. Thickness values and total number of passes were found to be inversely related. Roll surface finish and preload value affected the rate of reduction in a significant manner; hardness and developing anisotropy did not.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Rolling of Very Thin Sheets
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225036
dc.journal.fristpage53
dc.journal.lastpage59
dc.identifier.eissn1528-8889
dc.keywordsCopper
dc.keywordsAluminum
dc.keywordsSteel
dc.keywordsStrength (Materials)
dc.keywordsFinishes
dc.keywordsAnisotropy
dc.keywordsCarbon
dc.keywordsFracture (Process)
dc.keywordsStrips AND Thickness
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record