• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    The Rolling of Very Thin Sheets

    Thumbnail
    View/Open
    JEMTA8-26885#53_1.pdf (728.1Kb)
    Date
    1982
    Author
    R. F. Scrutton
    J. G. Lenard
    Metadata
    Show full item record
    Abstract
    Thin strip specimens were reduced to foil by passing them repeatedly between the rolls of a two-high mill at low speeds. Narrow specimens were tested to avoid complications caused by roll bending. Factors governing the rate of reduction were examined, these being roll preload value and roll surface finish for low carbon strips as well as material strength, hardness, and anisotropy for aluminum and copper. No minimum thickness was found for the steel specimens; for aluminum and copper limiting thickness values were obtained based on the onset of edge cracking and longitudinal fracture. Thickness values and total number of passes were found to be inversely related. Roll surface finish and preload value affected the rate of reduction in a significant manner; hardness and developing anisotropy did not.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/95914
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV