Show simple item record

dc.contributor.authorP. Broomhead
dc.contributor.authorR. J. Grieve
dc.date.accessioned2017-05-08T23:13:27Z
dc.date.available2017-05-08T23:13:27Z
dc.date.copyrightApril, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26887#102_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95891
dc.description.abstractThe present investigation was undertaken as a preliminary study into the influence of strain rate on the forming limit diagram for low carbon steel. For a variation in strain rate from 10−3 s−1 to 70 s−1 experiments have shown that, in the positive quadrant of the forming limit diagram, the position of the forming limit curve is lowered with increasing strain rate. Further, it is suggested that a degree of correlation exists between strain rate and the work hardening exponent “n,” and as such the influence of strain rate on the forming limit diagram manifests itself through the change in n value. Slow speed forming was carried out under oil pressure using a bulge test with elliptical dies. To attain higher strain rate a water-hammer forming technique was employed together with the same die sets as those used for bulge forming.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Strain Rate on the Strain to Fracture of a Sheet Steel Under Biaxial Tensile Stress Conditions
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225043
dc.journal.fristpage102
dc.journal.lastpage106
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsForming techniques
dc.keywordsCarbon steel
dc.keywordsSteel sheet
dc.keywordsWater hammer
dc.keywordsFracture (Process)
dc.keywordsTension AND Work hardening
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record