• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    The Effect of Strain Rate on the Strain to Fracture of a Sheet Steel Under Biaxial Tensile Stress Conditions

    Thumbnail
    View/Open
    JEMTA8-26887#102_1.pdf (923.8Kb)
    Date
    1982
    Author
    P. Broomhead
    R. J. Grieve
    Metadata
    Show full item record
    Abstract
    The present investigation was undertaken as a preliminary study into the influence of strain rate on the forming limit diagram for low carbon steel. For a variation in strain rate from 10−3 s−1 to 70 s−1 experiments have shown that, in the positive quadrant of the forming limit diagram, the position of the forming limit curve is lowered with increasing strain rate. Further, it is suggested that a degree of correlation exists between strain rate and the work hardening exponent “n,” and as such the influence of strain rate on the forming limit diagram manifests itself through the change in n value. Slow speed forming was carried out under oil pressure using a bulge test with elliptical dies. To attain higher strain rate a water-hammer forming technique was employed together with the same die sets as those used for bulge forming.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/95891
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV