Show simple item record

dc.contributor.authorD. A. Summers
dc.contributor.authorC. R. Barker
dc.date.accessioned2017-05-08T23:10:54Z
dc.date.available2017-05-08T23:10:54Z
dc.date.copyrightJune, 1981
dc.date.issued1981
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26382#147_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/94433
dc.description.abstractCurrent methods of in-situ gasification require that inter-well connection be by means of either reverse combustion burning or by directional drilling. High-pressure water jet drills concentrate the energy of cutting in a small area and the total thrust required to advance this system is thus minimized. This has been used advantageously to develop a drill for coal seams which can be lowered down a vertical well turned through a 90-deg angle and then advanced horizontally through the coal. A test unit operating at a pressure of 70 MPa and a flow rate of 90 L/min has been used to demonstrate, in a surface trial, the practicality of this concept for interconnecting two in-situ gasification wells located 20 m apart.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePotential Advantages to Water Jet Drilling for Use in In-Situ Coal Gasification Processes
dc.typeJournal Paper
dc.journal.volume103
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3230827
dc.journal.fristpage147
dc.journal.lastpage152
dc.identifier.eissn1528-8994
dc.keywordsDrilling
dc.keywordsCoal
dc.keywordsFuel gasification
dc.keywordsWater
dc.keywordsDrills (Tools)
dc.keywordsCombustion
dc.keywordsWells
dc.keywordsPressure
dc.keywordsFlow (Dynamics)
dc.keywordsThrust
dc.keywordsHigh pressure (Physics) AND Cutting
dc.treeJournal of Energy Resources Technology:;1981:;volume( 103 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record