• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Criterion for Allowable Lower Ball Joint Angle in Floating Drilling

    Thumbnail
    View/Open
    JERTD2-26380#242_1.pdf (713.6Kb)
    Date
    1980
    Author
    J. R. Fowler
    T. N. Gardner
    Metadata
    Show full item record
    Abstract
    In drilling from floating vessels, most operators and drilling contractors specify an allowable lower ball joint angle of 3–5 deg for drilling and 1–3 deg for running casing. Presently, no one uses tension in the drill pipe or casing as a factor in setting allowable ball joint angles. The results of the analysis detailed in this paper show that the allowable ball joint angles in use are justified for well depths less than 5000 ft below the ball joint. However, the allowable angle is too high for continual operation for well depths below the ball joint of 10,000 ft or more. The increased drill pipe or casing tension in deeper wells causes high alternating stresses in the drill pipe and high wear rates where the pipe bears against equipment in the ball joint region. The principal conclusion of this paper is that the allowable lower ball joint angle should not be constant, but should vary with the tension in the drill pipe as the well is being drilled.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/93132
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV