Show simple item record

dc.contributor.authorJ. L. Tevaarwerk
dc.contributor.authorR. Sowerby
dc.contributor.authorA. Plumtree
dc.date.accessioned2017-05-08T22:58:43Z
dc.date.available2017-05-08T22:58:43Z
dc.date.copyrightApril, 1975
dc.date.issued1975
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26840#136_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/87532
dc.description.abstractA series of warm and cold heading tests ranging from room temperature to 400 deg C have been conducted on 305 and copper bearing 302 stainless steel wires as well as 0.2 percent C steel wire using a fully instrumented double blow Waterbury-Farrel machine heading 100 blanks per minute. Total and frictional forces developed during the first blow using a variety of lubricants, together with the second blow loads have been recorded. The effectiveness of the different lubricants employed was examined. The optimum blank temperature for warm heading stainless steel is in the range 200 to 400 deg C where the punch loads are reduced about 25/30 percent, compared to cold heading. Within this temperature range the friction coefficient for the copper coated stainless steel possessing a stearate film on the surface remains relatively low (μ ∼ 0.01/0.02). Reduced punch loads are shown to effect an increase in punch life. For all temperatures the heading loads for the copper bearing 302 stainless steel were lower than for 305 stainless steel. Both these materials exhibit a weak dynamic strain aging effect compared with plain carbon steel. In fact the heading loads were higher between 300 deg and 400 deg C for the plain carbon steel. At room temperature components made from both copper bearing 302 stainless steel and 305 stainless steel possessed fewer shear cracks when employing the former material and this effect is attributed to a lower strain hardening rate.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleWarm and Cold Heading of Stainless Steel
dc.typeJournal Paper
dc.journal.volume97
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443273
dc.journal.fristpage136
dc.journal.lastpage143
dc.identifier.eissn1528-8889
dc.keywordsStainless steel
dc.keywordsStress
dc.keywordsTemperature
dc.keywordsCopper
dc.keywordsBearings
dc.keywordsBlanks
dc.keywordsWire
dc.keywordsLubricants
dc.keywordsCarbon steel
dc.keywordsForce
dc.keywordsFriction
dc.keywordsMachinery
dc.keywordsSteel
dc.keywordsShear (Mechanics)
dc.keywordsFracture (Materials) AND Work hardening
dc.treeJournal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record