Show simple item record

dc.contributor.authorAiham Adawi
dc.contributor.authorMaged A. Youssef
dc.contributor.authorMohamed Meshaly
dc.date.accessioned2017-05-08T22:32:06Z
dc.date.available2017-05-08T22:32:06Z
dc.date.copyrightApril 2015
dc.date.issued2015
dc.identifier.other48750573.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/82180
dc.description.abstractHollowcore slabs are commonly used in different types of structures. They usually include a 50-mm concrete topping. Structural engineers can use this topping to increase the slab load-carrying capacity. North American design standards relate the horizontal shear strength at the interface between hollowcore slabs and the concrete topping to the slab surface roughness. This paper presents the results of four push-off tests on hollowcore slabs supplied by two manufacturers and roughened using a conventional steel broom. The tested slabs sustained higher horizontal shear stresses than those specified by the design standards. Utilizing the data from the push-off tests, an analytical model was applied to evaluate the shear and peel stiffnesses,
dc.publisherAmerican Society of Civil Engineers
dc.titleAnalytical Modeling of the Interface between Lightly Roughened Hollowcore Slabs and Cast-In-Place Concrete Topping
dc.typeJournal Paper
dc.journal.volume141
dc.journal.issue4
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0001075
dc.treeJournal of Structural Engineering:;2015:;Volume ( 141 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record