Show simple item record

dc.contributor.authorK. J. R. Rasmussen
dc.contributor.authorG. J. Hancock
dc.date.accessioned2017-05-08T22:24:14Z
dc.date.available2017-05-08T22:24:14Z
dc.date.copyrightAugust 1993
dc.date.issued1993
dc.identifier.other44120486.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/79825
dc.description.abstractThe paper presents compression tests on square and circular stainless steel tubes, including stub column and long column tests. An important part of the test program was to quantify the increase in column strength resulting from cold work during the fabrication process. Tension and compression tests on coupons cut from finished tubes were also included in the test program, as were measurements of residual strains produced by the cold‐rolling process. A design method is proposed for stainless steel tubular columns. The method incorporates the increase in strength produced by the cold‐rolling process and is validated by comparing it to the test strengths. It is demonstrated that the proposed design procedure provides column strengths that are much closer to the test strengths than design strengths based on the annealed material properties. The design procedure proposed is an extension of that described in the
dc.publisherAmerican Society of Civil Engineers
dc.titleDesign of Cold‐Formed Stainless Steel Tubular Members. I: Columns
dc.typeJournal Paper
dc.journal.volume119
dc.journal.issue8
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)0733-9445(1993)119:8(2349)
dc.treeJournal of Structural Engineering:;1993:;Volume ( 119 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record