• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Design of Cold‐Formed Stainless Steel Tubular Members. I: Columns

    Thumbnail
    View/Open
    44120486.pdf (926.3Kb)
    Date
    1993
    Author
    K. J. R. Rasmussen
    G. J. Hancock
    Metadata
    Show full item record
    Abstract
    The paper presents compression tests on square and circular stainless steel tubes, including stub column and long column tests. An important part of the test program was to quantify the increase in column strength resulting from cold work during the fabrication process. Tension and compression tests on coupons cut from finished tubes were also included in the test program, as were measurements of residual strains produced by the cold‐rolling process. A design method is proposed for stainless steel tubular columns. The method incorporates the increase in strength produced by the cold‐rolling process and is validated by comparing it to the test strengths. It is demonstrated that the proposed design procedure provides column strengths that are much closer to the test strengths than design strengths based on the annealed material properties. The design procedure proposed is an extension of that described in the
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/79825
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV