Minimum Quantity Cutting Fluid Application for Grinding Weld Flash: Surface Integrity Evaluation

Abstract

The effect of the grinding process for weld flash removal on the surface integrity of the welded joint has not been researched. The surface integrity of the welded joint is essential for the bandsaw blade life and to prevent any premature failure at the weld joint due to fatigue loading (a band saw blade undergoes mainly cyclic bending fatigue during its service). In this study, the effects of using different cutting fluid combinations on the grinding of weld flash in medium carbon alloy steel were carried out. The use of compressed air (CA) as a sustainable solution for grinding weld flash was explored. An experimental investigation of four different cutting fluid applications (dry/no cutting fluid, compressed air, minimum quantity lubricant using vegetable oil, and minimum quantity coolant using water-soluble oil) was carried out. The surface roughness, sub-surface residual stresses, and microhardness of the ground region were measured. This is a first-of-the-kind study on the effect of the flash removal process on the surface integrity of the welded joint. The results show that the surface integrity of the welded joint is significantly influenced by the cutting fluid application used during the grinding process of the flash. Dry grinding, the current industry standard for grinding weld flash in band saw blades, produced surface tensile residual stresses (24.82 MPa), lowest sub-surface microhardness (43.28 HRc), and the highest surface roughness (3.40 µm). In comparison, the air application had the highest surface compressive residual stresses (−289.57 MPa), highest sub-surface microhardness (48.67 HRc), and relatively low surface roughness (1.61 µm). This study provides the road map for selecting the cutting fluid application for grinding weld flash produced by the resistance welding process in the band sawing industry.