Show simple item record

dc.contributor.authorTao Han
dc.contributor.authorChangyu Jin
dc.contributor.authorXiaole Hou
dc.contributor.authorXiaobo Liu
dc.contributor.authorYu Lu
dc.contributor.authorDong Liu
dc.date.accessioned2022-08-18T12:15:19Z
dc.date.available2022-08-18T12:15:19Z
dc.date.issued2022/05/10
dc.identifier.other%28ASCE%29GM.1943-5622.0002426.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4286290
dc.description.abstractFully grouted rockbolt is a form of reinforcement commonly used in underground projects. Its mechanical behavior is of vital importance to enhancing the stability of surrounding rock masses. To investigate the effect of different loading methods on the mechanical behaviors of rockbolt, the distinct element code PFC2D was adopted to simulate the pullout test on rockbolt and a compression test on the bolted rock mass, with Hongtoushan Copper Mine as the engineering background. The stress distribution along rockbolt and the maximum pullout capacity were analyzed. The results indicated that the loading method has significant effects on the mechanical behaviors of rockbolt. In the pullout test, the peak stress in the rockbolt always occurs near the free face. As the rock mass is a passive load-bearing component, the cracks and weak intercalations in the rock mass have little effect on the mechanical behaviors of the rockbolt. Meanwhile, as the external load acts directly on the outer end of rockbolt, the effect of the bearing plate cannot be reflected. However, in the compression test on the bolted rock mass, the peak stress in the rockbolt gradually transfers to greater depth. The existence of cracks and weak intercalations have an impact on the mechanical behaviors of the rockbolt. In addition, with increasing size of the bearing plate, the maximum pullout capacity of the rockbolt gradually increases. Comparison of the simulation results showed that the maximum pullout capacity obtained by the pullout test on a rockbolt is higher than that obtained by the compression test on a bolted rock mass. Therefore, appropriate reduction of the maximum pullout capacity obtained by the pullout test is suggested for rockbolt design, and the reduction factor should be in the range of 0.7–0.8.
dc.publisherASCE
dc.titleStudy on the Effect of Loading Method on Mechanical Behavior of Rockbolt Based on DEM Modeling
dc.typeJournal Article
dc.journal.volume22
dc.journal.issue7
dc.journal.titleInternational Journal of Geomechanics
dc.identifier.doi10.1061/(ASCE)GM.1943-5622.0002426
dc.journal.fristpage04022106
dc.journal.lastpage04022106-13
dc.page13
dc.treeInternational Journal of Geomechanics:;2022:;Volume ( 022 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record