• Login
    View Item 
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    •   DSpace Home
    • ASCE
    • International Journal of Geomechanics
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Study on the Effect of Loading Method on Mechanical Behavior of Rockbolt Based on DEM Modeling

    Thumbnail
    View/Open
    %28ASCE%29GM.1943-5622.0002426.pdf (3.866Mb)
    Date
    2022/05/10
    Author
    Tao Han
    Changyu Jin
    Xiaole Hou
    Xiaobo Liu
    Yu Lu
    Dong Liu
    Metadata
    Show full item record
    Abstract
    Fully grouted rockbolt is a form of reinforcement commonly used in underground projects. Its mechanical behavior is of vital importance to enhancing the stability of surrounding rock masses. To investigate the effect of different loading methods on the mechanical behaviors of rockbolt, the distinct element code PFC2D was adopted to simulate the pullout test on rockbolt and a compression test on the bolted rock mass, with Hongtoushan Copper Mine as the engineering background. The stress distribution along rockbolt and the maximum pullout capacity were analyzed. The results indicated that the loading method has significant effects on the mechanical behaviors of rockbolt. In the pullout test, the peak stress in the rockbolt always occurs near the free face. As the rock mass is a passive load-bearing component, the cracks and weak intercalations in the rock mass have little effect on the mechanical behaviors of the rockbolt. Meanwhile, as the external load acts directly on the outer end of rockbolt, the effect of the bearing plate cannot be reflected. However, in the compression test on the bolted rock mass, the peak stress in the rockbolt gradually transfers to greater depth. The existence of cracks and weak intercalations have an impact on the mechanical behaviors of the rockbolt. In addition, with increasing size of the bearing plate, the maximum pullout capacity of the rockbolt gradually increases. Comparison of the simulation results showed that the maximum pullout capacity obtained by the pullout test on a rockbolt is higher than that obtained by the compression test on a bolted rock mass. Therefore, appropriate reduction of the maximum pullout capacity obtained by the pullout test is suggested for rockbolt design, and the reduction factor should be in the range of 0.7–0.8.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4286290
    Collections
    • International Journal of Geomechanics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV