• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Progressive Collapse Resistance of Emulative Precast Concrete Frames with Various Reinforcing Details

    Thumbnail
    View/Open
    %28ASCE%29ST.1943-541X.0003065.pdf (1.620Mb)
    Date
    8/1/2021
    Author
    Kai Qian
    Shi-Lin Liang
    Feng Fu
    Yi Li
    Metadata
    Show full item record
    Abstract
    In this paper, three precast concrete (PC) frames and one cast-in-situ reinforced-concrete (RC) frame were cast and tested to investigate the load-resisting mechanisms of emulative PC frames with various reinforcing details to resist progressive collapse. In the beams of PC frames, the top reinforcement was continuous without curtailment while the bottom reinforcement had different anchorage strength. Test results indicated that, in the event of middle column removal, similar to RC frame, beam action, compressive arch action (CAA), and tensile catenary action (TCA) could be developed sequentially in PC frames with emulative connections, PC frames with sufficient anchorage strength or additional bottom U-shaped bars passing through the middle joint could obtain similar level of CAA capacity as RC frame. However, they may achieve relatively lower TCA capacity due to higher bond strength between the top reinforcement and cast-in-situ topping layer in beams, owing to higher concrete strength in the topping layer, resulting in earlier fracture of the beam top reinforcements. Conversely, PC frames with insufficient anchorage could achieve comparable TCA capacity as RC frame. However, their CAA capacity was less than that of RC frames due to pulling-out failure of bottom reinforcements, preventing further development of strain hardening at beam action and CAA stages. Based on test results and analytical studies, it was found that, similar to RC frames, PC frames with emulative connections could provide sufficient rotational capacity to ensure development of tie-force as required by the design guidelines.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4270438
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV