• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Reliability Analysis and Design Considerations for Exposed Column Base Plate Connections Subjected to Flexure and Axial Compression

    Thumbnail
    View/Open
    (ASCE)ST.1943-541X.0002903.pdf (1.690Mb)
    Date
    2/1/2021
    Author
    Biao Song
    Carmine Galasso
    Amit Kanvinde
    Metadata
    Show full item record
    Abstract
    Exposed column base plate (ECBP) connections are commonly used in steel moment resisting frames. Current approaches for their design are well-established from a mechanistic standpoint. However, the reliability of connections designed as per these approaches is not as well understood. A detailed reliability analysis of the prevalent approach in the United States is performed in this study by using 59 design scenarios from steel moment frames subjected to combinations of dead, live, wind, and seismic loads. The analysis is conducted through Monte Carlo sampling reflecting uncertainties in the loads, material properties, component geometry, as well as demand and capacity models for the various components (e.g., base plate, footing, anchor rods) of the connection. Results indicate that the current design approach leads to unacceptable and inconsistent probabilities of failure across the various components. This is attributed to: (1) the use of a resistance factor for the footing bearing stress that artificially alters flexural demands on the base plate, and (2) the calibration of resistance factors for the plate and anchors without appropriate consideration of variability in demands. Two alternative approaches are examined as prospective refinements to the current approach. One eliminates the resistance factor for the bearing stress when used to determine flexural demands in the base plate, while the other considers overall failure of the connection rather than failure of individual components within the connection. For both approaches, new resistance factors are calibrated to provide consistent and acceptable probabilities of failure across all limit states and all types of loading. Design and cost implications of these alternative approaches are summarized.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4269576
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV