Show simple item record

dc.contributor.authorZheng, Wei
dc.contributor.authorZhang, Xiangyi
dc.contributor.authorMa, Rong
dc.contributor.authorLi, Yong
dc.date.accessioned2019-02-28T11:01:50Z
dc.date.available2019-02-28T11:01:50Z
dc.date.copyright8/29/2017 12:00:00 AM
dc.date.issued2018
dc.identifier.issn0022-1481
dc.identifier.otherht_140_02_022801.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4251901
dc.description.abstractTransient thermal behavior modeling and simulation is a key issue in predicting flight performance of stratospheric lighter-than-air (LTA) vehicles, such as airships or balloons. To reduce computational load of the transient thermal model without significant loss of accuracy, first this paper adopted an analytical model of view factor from the element surfaces to the Earth and constructed a full distributed parameter transient thermal model. Then, the full model was validated by comparing the predictions obtained from the full model with the flight experimental data. The comparison results show that the divergence of the predicted average internal gas temperatures from the flight data is about 0.4%, and the divergence of the predicted envelop temperatures from the flight data is less than 2.4%. Furthermore, considering that the effect of the net radiation heat transfer among the inner surface enclosure on average internal gas temperature is far less than radiation heat transfer of the outer surfaces, the full model was simplified by omitting radiant heat exchange within the inner surface enclosure. The accuracy of the simplified model was investigated by comparing the predictions of average internal gas temperature and skin temperature distribution between the simplified model and full model under various conditions, such as flight time, altitude, and different external skin thermal properties. The comparison results indicate that the simplified model agrees well with the full model. The discrepancies of the predicted average internal gas temperature between the two models are less than 0.3% under most conditions, and the discrepancies of the predicted temperature distribution between the two models are also acceptable when the LTA vehicle, especially with low absorptivity/emissivity ratio coatings, operates at about 20 km altitude.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Simplified Thermal Model and Comparison Analysis for a Stratospheric Lighter-Than-Air Vehicle
dc.typeJournal Paper
dc.journal.volume140
dc.journal.issue2
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4037194
dc.journal.fristpage22801
dc.journal.lastpage022801-9
dc.treeJournal of Heat Transfer:;2018:;volume( 140 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record