Journal of Energy Resources Technology: Recent submissions
Now showing items 2901-2920 of 3450
-
Spherical Phase-Change Energy Storage With Constant Temperature Heat Injection
(The American Society of Mechanical Engineers (ASME), 1987)Storage of thermal energy due to latent heat involved during outward radial melting of a phase-change material contained in a spherical shell is solved using variational, integral and quasi-steady ... -
An Improved Model for Predicting Heat Losses and Pressure Changes in Steam Injection Wells—Part 1: Model Development
(The American Society of Mechanical Engineers (ASME), 1987)An improved model for predicting heat losses and pressure changes in steam injection wells is presented. The model incorporates a new two-phase, annular-mist flow pressure change model with heat ... -
Correlating the PVT Properties of Nigerian Crudes
(The American Society of Mechanical Engineers (ASME), 1987)Existing correlations for predicting solution gas oil ratio, R s , and oil formation volume factor, B o , gave standard deviations as high as 50 and 12 percent, respectively, for Nigerian ... -
The Development Study of a Centrifuging Technique for Oilfield Production Pit Closure
(The American Society of Mechanical Engineers (ASME), 1987)A full-scale study was performed of a centrifuge-based process for dewatering oilfield production waste sludges in order to investigate an application of the process to an oilfield production ... -
A Mechanistic Model for Two-Phase Vertical Slug Flow in Pipes
(The American Society of Mechanical Engineers (ASME), 1987)This paper presents the formulation of a mechanistic model for slug flow in vertical pipes. The equations required to determine holdup, the relevant velocities and pressure loss are presented. ... -
Transient Natural Convection on a Vertical Flat Plate Embedded in a High-Porosity Medium
(The American Society of Mechanical Engineers (ASME), 1987)This paper provides an analysis of the non-Darcian effect on transient natural convection of a vertical flat plate embedded in a high-porosity medium. The plate surface is either maintained at ... -
Natural Convection of Non-Newtonian Fluids About a Horizontal Surface in a Porous Medium
(The American Society of Mechanical Engineers (ASME), 1987)The problem of natural convection of a non-Newtonian power-law fluid about a horizontal impermeable surface in the porous medium is considered, where the plate is assumed with a nonuniform heat ... -
A Thermodynamically Based Model for Ash Fusion Temperature
(The American Society of Mechanical Engineers (ASME), 1987)This paper describes a thermodynamically based correlation between coal ash fusion temperatures and ash composition. A wide range of data from the literature was used to obtain the values of ... -
The Performance of Fabric Filters in a Pilot Baghouse During Coal Water Fuel Combustion Trials
(The American Society of Mechanical Engineers (ASME), 1987)Energy, Mines and Resources, Canada, together with the New Brunswick Electric Power Commission (N.B. Power) and Cape Breton Development Corporation have undertaken a program in eastern Canada to ... -
On the Vortex-Induced Oscillation of Long Structural Elements
(The American Society of Mechanical Engineers (ASME), 1987)Previous solutions to the vortex-induced vibration of structures have been primarily based on modal analysis, using a one or two-mode approximation. Such an analysis is generally meaningful only ... -
Fatigue Loads on the Foundation due to Turbine Rotor Eccentricity
(The American Society of Mechanical Engineers (ASME), 1987)This paper is concerned with the effect of rotor eccentricity on the turbine behavior and the shaft deflection which affect the load on the foundation and on the turbine bearings. An analytical ... -
A Laboratory Study of Two Straddle-Packer Systems Under Simulated Hydrofrac Stress-Measurement Conditions
(The American Society of Mechanical Engineers (ASME), 1987)The mechanical behavior of two straddle-packer systems subjected to pressure histories which replicated hydrofracture stress-measurement procedures has been investigated. The systems were pressurized ... -
Vortex-Induced Response of a Flexible Cylinder in a Sheared Current
(The American Society of Mechanical Engineers (ASME), 1986)In this paper we outline a method for the approximate prediction of the static and lift responses of a flexible cylinder in a unidirectional variable stream. Our prediction is based on ... -
Sensitivity of Flexibility Monitoring of Offshore Jacket Platforms
(The American Society of Mechanical Engineers (ASME), 1986)Flexibility monitoring is a vibration-based method for simplifying the detection of major underwater damage on offshore jacket platforms. Ambient vibrations are detected at each of the underwater ... -
Time Domain Simulation of Ship Steering Gear Control Systems
(The American Society of Mechanical Engineers (ASME), 1986)Considering the effects of oil compressibility, leakage, hydrodynamic damping and friction, in addition to other nonlinearities, such as bang-bang relay, pump saturation and limiters of oil pressure ... -
An Approximate Solution for the Potential Flow of a Pore Fluid Into a Slotted Cylinder
(The American Society of Mechanical Engineers (ASME), 1986)Conformal mapping may be used to approximate the two-dimensional pore pressure distribution around a cylinder with a single longitudinal slot. A nonsymmetric flow field can significantly affect ... -
Vortex-Induced Vibration and Drag Coefficients of Long Cables Subjected to Sheared Flows
(The American Society of Mechanical Engineers (ASME), 1986)The vortex-induced vibration response of long cables subjected to vertically sheared flow was investigated in two field experiments. In a typical experiment, a weight was hung over the side of ... -
The Coefficient of Friction Between Sea Ice and Various Materials Used in Offshore Structures
(The American Society of Mechanical Engineers (ASME), 1986)When structures having inclined surfaces, such as cone-type and inclined-pile structures, are constructed in coastal and offshore cold regions, sea ice forces must be considered in their design. ... -
On the Collapse of Inelastic Thick-Walled Tubes Under External Pressure
(The American Society of Mechanical Engineers (ASME), 1986)The collapse of long thick-walled tubes under external pressure is studied both experimentally and analytically. A two-dimensional nonlinear formulation of the problem is presented. The formulation ... -
Cable Recovery With Overrun
(The American Society of Mechanical Engineers (ASME), 1986)Cable is normally recovered by hauling in from ahead, with the cable guiding the ship. In an early paper, Zajac presented a method for recovery, proposed by Shea, in which the cable is ...