Journal of Heat Transfer: Recent submissions
Now showing items 3601-3611 of 3611
-
Effects of Fin Shapes and Arrangements on Heat Transfer for Impingement∕Effusion Cooling with Crossflow
(The American Society of Mechanical Engineers (ASME), 2007)The present paper has investigated the effects of fins on the flow and heat∕mass transfer characteristics for the impingement∕effusion cooling with crossflow. The circular or rectangular fins are ... -
Mass (Heat) Transfer Downstream of Blockages With Round and Elongated Holes in a Rectangular Channel
(The American Society of Mechanical Engineers (ASME), 2007)Turbulent forced convective mass (heat) transfer downstream of blockages with round and elongated holes in a rectangular channel was studied. The blockages and the channel had the same 12:1 ... -
Discrete Green’s Function Measurements in a Serpentine Cooling Passage
(The American Society of Mechanical Engineers (ASME), 2007)The inverse discrete Green’s function (IDGF) is a heat transfer coefficient that is valid for arbitrarily complex thermal boundary conditions. It was measured using a rapid experimentation technique ... -
Magnetohydrodynamic Flow Past a Vertical Plate With Radiative Heat Transfer
(The American Society of Mechanical Engineers (ASME), 2007)The problem of steady, laminar, magnetohydrodynamic flow past a semi-infinite vertical plate is studied. The primary purpose of this study was to characterize the effects of thermal radiative ... -
Assessment of a Second-Moment Closure Model for Strongly Heated Internal Gas Flows
(The American Society of Mechanical Engineers (ASME), 2007)Both low- and high-Reynolds-number versions of the stress-ω model of Wilcox (Turbulence Modeling for CFD, 2nd ed., DCW Industries, Inc.) were used to predict velocity and heat transfer data in ... -
Effect of the Temperature Difference Aspect Ratio on Natural Convection in a Square Cavity for Nonuniform Thermal Boundary Conditions
(The American Society of Mechanical Engineers (ASME), 2007)The present numerical investigation deals with steady natural convection flow in a closed square cavity when the bottom wall is sinusoidal heated and vertical walls are linearly heated, whereas ... -
Internal Cooling in 4:1 AR Passages at High Rotation Numbers
(The American Society of Mechanical Engineers (ASME), 2007)Heat transfer and pressure drop measurements are reported for a rotating 4:1 aspect ratio (AR) smooth two-pass coolant passage for Reynolds number in the range of 10,000–150,000, rotation number ... -
A Periodic-Transient Method for High-Resolution Heat Transfer Measurement on Two-Dimensional Curved Surfaces
(The American Society of Mechanical Engineers (ASME), 2007)Measurement of heat transfer distribution is frequently required in engineering. However, some heat transfer techniques are not able to measure accurately on two-dimensional curved surfaces. In ... -
A Theoretical Study on Convective Condensation of Water Vapor From Humid Air in Turbulent Flow in a Vertical Duct
(The American Society of Mechanical Engineers (ASME), 2007)The problem of condensation of water vapor from humid air flowing in a duct in turbulent flow is formulated theoretically. Vapor condensing at the dew-point temperature of the vapor-air mixture ... -
Optically Based Rapid Heat Transfer Measurements in Complex Internal Flows
(The American Society of Mechanical Engineers (ASME), 2007)An optically based technique was developed that involves fabrication of a thin-walled plastic model with laser heating applied to a small section of the outer surface. The heat flux distribution ... -
Effective Conductivity of a Composite in a Primitive Tetragonal Lattice of Highly Conducting Spheres in Resistive Thermal Contact With the Isolating Matrix
(The American Society of Mechanical Engineers (ASME), 2007)A state-of-the-art study and a physical and numerical 3D finite element study of anisotropic conduction through composites filled with isometric inclusions of different conductivity were performed ...