Journal of Heat Transfer: Recent submissions
Now showing items 2781-2800 of 3611
-
In Appreciation
(The American Society of Mechanical Engineers (ASME), 2011)On behalf of the ASME Heat Transfer Division, I wish to express our deepest appreciation to Yogesh Jaluria for his dedicated service and excellent leadership as Editor of the ASME Journal of ... -
Use of Optimal Homotopy Asymptotic Method and Galerkin’s Finite Element Formulation in the Study of Heat Transfer Flow of a Third Grade Fluid Between Parallel Plates
(The American Society of Mechanical Engineers (ASME), 2011)We investigate the effectiveness of the optimal homotopy asymptotic method (OHAM) in solving nonlinear systems of differential equations. In particular we consider the heat transfer flow of a ... -
An Approximate Analytical Solution for Electro-Osmotic Flow of Power-Law Fluids in a Planar Microchannel
(The American Society of Mechanical Engineers (ASME), 2011)The present investigation considers the fully developed electro-osmotic flow of power-law fluids in a planar microchannel subject to constant wall heat fluxes. Using an approximate velocity ... -
Effective Thermal Properties of Layered Systems Under the Parabolic and Hyperbolic Heat Conduction Models Using Pulsed Heat Sources
(The American Society of Mechanical Engineers (ASME), 2011)In this work, transient heat transport in a flat layered system, with interface thermal resistance, is analyzed, under the approach of the Cattaneo–Vernotte hyperbolic heat conduction model using ... -
Transient Two-Phase Flow Patterns by Application of a High Voltage Pulse Width Modulated Signal and the Effect on Condensation Heat Transfer
(The American Society of Mechanical Engineers (ASME), 2011)The objectives of this study are (i) to determine the transient phase redistributions of a two-phase flow in a smooth horizontal annular channel by applying high voltage pulses to induce ... -
Heat Transfer Analysis of Room-Temperature Finned-Tube Evaporator for Cryogenic Nitrogen
(The American Society of Mechanical Engineers (ASME), 2011)The behavior of cryogenic nitrogen in a room-temperature evaporator six meters long is analyzed. Trapezoid fins are employed to enhance the heat flux supplied by the environment. The steady-state ... -
Heat Transfer Experiments in a Confined Jet Impingement Configuration Using Transient Techniques
(The American Society of Mechanical Engineers (ASME), 2011)A confined jet impingement configuration has been investigated in which the matter of interest is the convective heat transfer from the air flow to the passage walls. The geometry is similar ... -
Erratum: “Review of Heat Conduction in Nanofluids”[Journal of Heat Transfer, 2011, 133(4), p. 040801]
(The American Society of Mechanical Engineers (ASME), 2011)Some corrections on citation/reference are needed in this paper, as follows:Page 040801-1, the citation in Line 6 from bottom (right column) should read “Refs. [5, 17, 19],” rather than “Refs. ... -
Erratum: “A Design and Rating Method for Shell-and-Tube Heat Exchangers with Helical Baffles” [ASME J. Heat Transfer, 2010, 132(5), p. 051802]
(The American Society of Mechanical Engineers (ASME), 2011)There are some errors in Eq. 22, Table 1, and nomenclature. The corrections of these errors are shown below: Display FormulaS2z=0.5(B-Sp/cosβ)[D1-Ds+Ds-dott(tt-do)] (22) Do/Di in Table 1 should ... -
Forced Convection Along the Wavy Surface
(The American Society of Mechanical Engineers (ASME), 2011)In this study, Prandtl’s transposition theorem is used to stretch the ordinary coordinate-system in certain direction. The small wavy surface can be transferred into a calculable plane ... -
Robust Thermal Performance of a Flat-Plate Oscillating Heat Pipe During High-Gravity Loading
(The American Society of Mechanical Engineers (ASME), 2011)The thermal performance of a miniature, three-dimensional flat-plate oscillating heat pipe (3D FP-OHP) was experimentally investigated during high-gravity loading with nonfavorable evaporator positioning. ... -
Experimental Determination of Spectral Transmittance of Porous Cerium Dioxide in the Range 900–1700 nm
(The American Society of Mechanical Engineers (ASME), 2011)Overall transmittance of porous cerium dioxide is measured in the spectral range of 900–1700 nm using dispersive spectroscopy. Dense and porous samples of cerium dioxide with average porosities ... -
Erratum: “A Quasidependent Scattering Radiative Properties Model for High Density Fiber Composites” [Journal of Heat Transfer, 2010, 132(2), p. 023303]
(The American Society of Mechanical Engineers (ASME), 2011)The typographical errors in this paper occur in Eqs. 13,14,15 in which the Hankel function of the second kind was inadvertently denoted as the integer Bessel function. The correct notations ... -
Erratum: “Study of Laminar Forced Convection of Radiating Gas Over an Inclined Backward Facing Step Under Bleeding Condition Using the Blocked-Off Method” [ASME J. Heat Transfer, 2011, 133(7), p. 072702]
(The American Society of Mechanical Engineers (ASME), 2011)There are three mistakes in typing the formula which are as follows: On the right hand of Eq. 4, the radiative heat flux (∇·qr) must be negative, but in the paper, it is positive. The ... -
Turbulent Heat Transfer Over a Moving Surface Due to Impinging Slot Jets
(The American Society of Mechanical Engineers (ASME), 2011)In the present paper, turbulent heat transfer characteristics of submerged slot jets impinging on a moving surface at a constant temperature up to a Reynolds number of 50,000 have been studied. ... -
Entrance and Temperature Dependent Viscosity Effects on Laminar Forced Convection in Straight Ducts With Uniform Wall Heat Flux
(The American Society of Mechanical Engineers (ASME), 2011)In this paper a parametric investigation is carried out on the effects of temperature dependent viscosity in simultaneously, i.e., hydro-dynamically and thermally, developing laminar flows of ... -
Nucleate Pool Boiling Heat Transfer Measurement and Flow Visualization for Ammonia-Water Mixture
(The American Society of Mechanical Engineers (ASME), 2011)Visualization of bubble nucleation during nucleate pool boiling outside a vertical cylindrical heated surface was done for ammonia-water binary mixture in order to obtain a descriptive behavior ... -
Heat Transfer and Flow Resistance Characteristics of Louver Fin Geometry for Automobile Applications
(The American Society of Mechanical Engineers (ASME), 2011)The present work was conducted to investigate the air-side pressure drop and heat transfer performance of the louver fin-tube heat exchanger for automobile applications. Fourteen kinds of louver ... -
A Study on the Importance of Natural Convection During Solidification in Rectangular Geometry
(The American Society of Mechanical Engineers (ASME), 2011)In this study, solidification process inside a water filled rectangular cavity is numerically investigated. The mathematical model is validated by comparing the current numerical predictions with ... -
Experimental Investigation of Fouling Behavior of 90/10 Cu/Ni Tube by Heat Transfer Resistance Monitoring Method
(The American Society of Mechanical Engineers (ASME), 2011)This paper describes an advanced monitoring system for fouling phenomenon in a wide range of tubular heat exchangers such as condensers and intercoolers. First, a mathematical model of fouling ...