Journal of Heat Transfer: Recent submissions
Now showing items 2681-2700 of 3611
-
Scaling of Natural Convection of an Inclined Flat Plate: Sudden Cooling Condition
(The American Society of Mechanical Engineers (ASME), 2011)The natural convection boundary layer adjacent to an inclined plate subject to sudden cooling boundary condition has been studied. It is found that the cold boundary layer adjacent to the plate ... -
Erratum: “Therporaoustic Convection: Modeling and Analysis of Flow, Thermal, and Energy Fields” [Journal of Heat Transfer, 2009, 131(10), p. 101011]
(The American Society of Mechanical Engineers (ASME), 2011)The authors regret that the following typos occurred in the above article: In the abstract, the word “therporacoustic” should be “therporaoustic.”On p. 3, three lines above Sec. 2.2, the word ... -
Development of a General Dynamic Pressure Based Single-Phase Spray Cooling Heat Transfer Correlation
(The American Society of Mechanical Engineers (ASME), 2011)One of the main challenges of spray cooling technology is the prediction of local and average heat transfer coefficients on the heater surface. It is hypothesized that the local heat transfer ... -
Transient Aspects of Heat Flux Bifurcation in Porous Media: An Exact Solution
(The American Society of Mechanical Engineers (ASME), 2011)The transient thermal response of a packed bed is investigated analytically. A local thermal nonequilibrium model is used to represent the energy transport within the porous medium. The heat ... -
Mineral Fouling Control by Underwater Plasma Discharge in a Heat Exchanger
(The American Society of Mechanical Engineers (ASME), 2011)The excessive mineral contents in water circulation systems could cause severe fouling in heat transfer equipment. The present study investigated the effect of underwater pulsed spark discharges ... -
Visualization of Two-Phase Flows in Nanofluid Oscillating Heat Pipes
(The American Society of Mechanical Engineers (ASME), 2011)Two-phase flows in an oscillating heat pipe (OHP) charged with deionized (DI) water and a nanofluid (0.268% v/v) were experimentally investigated. The OHP was made of quartz glass tube (with ... -
Pool Boiling Heat Transfer and Bubble Dynamics Over Plain and Enhanced Microchannels
(The American Society of Mechanical Engineers (ASME), 2011)Pool boiling is of interest in high heat flux applications because of its potential for removing large amount of heat resulting from the latent heat of evaporation and little pressure drop ... -
Parametric Numerical Study of Flow and Heat Transfer in Microchannels With Wavy Walls
(The American Society of Mechanical Engineers (ASME), 2011)Wavy channels were investigated in this paper as a passive scheme to improve the heat transfer performance of laminar fluid flow as applied to microchannel heat sinks. Parametric study of ... -
Second Law Analysis for Free Convection in Non-Newtonian Fluids Over a Horizontal Plate Embedded in a Porous Medium: Prescribed Surface Temperature
(The American Society of Mechanical Engineers (ASME), 2011)Second law characteristics of heat transfer and fluid flow due to free convection of non-Newtonian fluids over a horizontal plate with prescribed surface temperature in a porous medium are ... -
Natural Convection in a Quadrantal Cavity Heated and Cooled on Adjacent Walls
(The American Society of Mechanical Engineers (ASME), 2011)In this study, experimental and numerical analyses of natural convection in a quadrantal cavity heated and cooled on adjacent walls have been made to examine heat and fluid flow. Experimental ... -
Diffusion-Thermo Effects on Free Convective Heat and Mass Transfer Flow in a Vertical Channel With Symmetric Boundary Conditions
(The American Society of Mechanical Engineers (ASME), 2011)This article investigates the influence of diffusion-thermo effect on transient free convective heat and mass transfer flow in a channel bounded by two infinite vertical parallel plates. Fully ... -
Flow and Heat Transfer Over a Continuously Moving Flat Plate in a Porous Medium
(The American Society of Mechanical Engineers (ASME), 2011)The effects of the presence of an isotropic solid matrix and radiation on the forced convection boundary layer past a continuously moving flat plate is studied theoretically. The transformed ... -
Prediction of Thermal Conductivity and Convective Heat Transfer Coefficient of Nanofluids by Local Composition Theory
(The American Society of Mechanical Engineers (ASME), 2011)In this study, a new method based on the local composition theory has been developed to predict thermal conductivity, convective heat transfer coefficient, and viscosity of nanofluids. The ... -
Investigation on Intertube Falling-Film Heat Transfer and Mode Transitions of Aqueous-Alumina Nanofluids
(The American Society of Mechanical Engineers (ASME), 2011)Horizontal-tube falling-film heat transfer characteristics of aqueous aluminum oxide nanofluids at concentrations of 0 vol %, 0.05 vol %(0.20 wt %), 0.5 vol %(1.96 wt %), 1 vol %(3.86 wt %) ... -
Generalization of the Heat Transfer Coefficient Concept for System Simulation
(The American Society of Mechanical Engineers (ASME), 2011)Large progress has been realized in modeling conduction heat transfer problems over the past decade by the introduction of high performance compact thermal models (CTMs) mainly developed for ... -
A Review of Microscale Transport in the Thermal Processing of New and Emerging Advanced Materials
(The American Society of Mechanical Engineers (ASME), 2011)This paper reviews the microscale transport processes that arise in the fabrication of advanced materials. In many cases, the dimensions of the device being fabricated are in the micrometer ... -
On the Cooling of Electronics With Nanofluids
(The American Society of Mechanical Engineers (ASME), 2011)Nanofluids have been proposed to improve the performance of microchannel heat sinks. In this paper, we present a systematic characterization of aqueous silica nanoparticle suspensions with ... -
Numerical Analysis of Specific Absorption Rate and Heat Transfer in the Human Body Exposed to Leakage Electromagnetic Field at 915 MHz and 2450 MHz
(The American Society of Mechanical Engineers (ASME), 2011)In recent years, society has increased utilization of electromagnetic radiation in various applications. This radiation interacts with the human body and may lead to detrimental effects on human ... -
Thermovibrational Instability in a Fluid Saturated Anisotropic Porous Medium
(The American Society of Mechanical Engineers (ASME), 2011)A comprehensive investigation is made to understand the effect of harmonic vibration on the onset of convection in a horizontal anisotropic porous layer heated either from below or from above. ... -
Validation and Analysis of Numerical Results for a Varying Aspect Ratio Two-Pass Internal Cooling Channel
(The American Society of Mechanical Engineers (ASME), 2011)Numerical results for an internal ribbed cooling channel including a 180 deg bend with a 2:1 inlet and a 1:1 aspect ratio outlet channel were validated against experimental results in terms ...