Journal of Structural Engineering: Recent submissions
Now showing items 4781-4800 of 10765
-
Experimental Studies of Reinforced Concrete Bridge Columns under Axial Load Plus Biaxial Bending
(American Society of Civil Engineers, 2010)The pseudodynamic testing of two reinforced concrete bridge columns with a reduced scale of 2/5 was performed to obtain their seismic responses to near-fault ground motions. An identical column was also cyclically tested ... -
Rational Fraction Polynomial Method and Random Decrement Technique for Force-Excited Acceleration Responses
(American Society of Civil Engineers, 2009)This paper addresses a parameter identification problem of a linear dynamic system resulting from forced acceleration responses when input forces are unknown. The problem is attributed to an input force imposed on its ... -
Aerodynamic Damping in the Along-Wind Response of Tall Buildings
(American Society of Civil Engineers, 2010)We present a novel methodology for the estimation of the aerodynamic damping that affects the along-wind response of tall buildings. The estimation uses (1) measurements of the external pressures on the windward and leeward ... -
Seismic Behavior of Reinforced Concrete Exterior Wide Beam-Column Joints
(American Society of Civil Engineers, 2010)An experimental and numerical investigation carried out on RC wide beam-column joints when subjected to seismic loads is reported within this paper. The experimental study was conducted by subjecting three full-scale wide ... -
Assessment of Existing Structures Based on Identification
(American Society of Civil Engineers, 2010)A nondestructive damage detection approach based on measured structural responses is presented and verified by controlled laboratory experiments and by tests on real structures. In the experiments, defined magnitudes of ... -
Optimal Tuning of Amplitude Proportional Coulomb Friction Damper for Maximum Cable Damping
(American Society of Civil Engineers, 2010)This paper investigates numerically the optimal tuning of Coulomb friction dampers on cables, where the optimality criterion is maximum additional damping in the first vibration mode. The expression for the optimal friction ... -
Effectiveness of Some Strengthening Options for Masonry-Infilled RC Frames with Open First Story
(American Society of Civil Engineers, 2009)Strengthening of masonry-infilled reinforced concrete (RC) frame buildings with an open first story is needed because of the inherent irregularity in such buildings resulting in their poor performance as observed during ... -
Seismic Assessment of Existing RC Frames: Probabilistic Approach
(American Society of Civil Engineers, 2009)Recent earthquakes have shown that research in earthquake engineering has to be focused on the assessment of vulnerability of existing constructions lacking appropriate seismic resisting characteristics. In fact, older ... -
Robustness to Uncertainty: An Alternative Perspective in Realizing Uncertainty in Modeling Deflection of Reinforced Concrete Structures
(American Society of Civil Engineers, 2009)This paper describes an alternative perspective in evaluating of computational models for predicting deflection of cracked reinforced concrete (RC) structures. The concept of robustness to uncertainty in modeling input ... -
Steel Plate Shear Walls with Various Infill Plate Designs
(American Society of Civil Engineers, 2009)An experimental study was performed to investigate the structural capacity of steel plate walls with various infill plate designs. Five three-story steel plate shear walls with thin infill plates were tested. The parameters ... -
Discussion of “Conceptual Seismic Design of Regular Frames Based on the Concept of Uniform Damage” by Kyungha Park and Ricardo A. Medina
(American Society of Civil Engineers, 2009) -
Strength of Screw Connections in Cold-Formed Steel Construction
(American Society of Civil Engineers, 2009)This paper presents a review of the design provisions for screw-fastened cold-formed steel connections in the United States, including criteria for testing and evaluating the strength of screw fasteners. In addition, the ... -
Stochastic Assessment of Timing and Efficiency of Maintenance for Corroding RC Structures
(American Society of Civil Engineers, 2009)Reinforced concrete (RC) structures in a chloride environment are exposed to a particularly aggressive form of deterioration. Managing the maintenance and repair of structures subjected to these conditions is an important ... -
Seismic Design of High-Rise Concrete Walls: Reverse Shear due to Diaphragms below Flexural Hinge
(American Society of Civil Engineers, 2009)High-rise concrete shear walls are often supported near or below grade by stiff floor diaphragms connected to perimeter foundation walls. When a large portion of the overturning moment in the wall is transferred to the ... -
Action of Individual Bouncing on Structures
(American Society of Civil Engineers, 2009)This paper investigates the action of an individual bouncing on a structure, including the load generated and the effect on the dynamic behavior of the structure. A simply supported beam at The University of Manchester is ... -
Serviceability Reliability of Reinforced Concrete Beams with Corroded Reinforcement
(American Society of Civil Engineers, 2009)To date, attention of researchers concentrated mainly on the serviceability failure of corroded reinforced concrete (RC) beams caused by excessive cracking. However, cracking of the concrete cover and a reduction in the ... -
New Lateral Force Distribution for Seismic Design of Structures
(American Society of Civil Engineers, 2009)In the conventional seismic design methods, heightwise distribution of equivalent seismic loads seems to be related implicitly on the elastic vibration modes. Therefore, the employment of such a load pattern does not ... -
Dynamics of a Class of Horizontal Setback Buildings with Flexible Floor Diaphragm
(American Society of Civil Engineers, 2009)This technical note presents a convenient modeling/design procedure for a class horizontal setback building to minimize the adverse effect of in-plane floor flexibility. Existence of such a class requires proportional ... -
Closure to “Conceptual Seismic Design of Regular Frames Based on the Concept of Uniform Damage” by Kyungha Park and Ricardo A. Medina
(American Society of Civil Engineers, 2009) -
Effects of Axial Compression Load and Eccentricity on Seismic Behavior of Nonseismically Detailed Interior Beam-Wide Column Joints
(American Society of Civil Engineers, 2009)Six full-scale nonseismically detailed reinforced concrete interior beam-wide column joints were tested to investigate the seismic behavior of the joints. Axial compression loads varying from zero to high magnitude, as ...