Journal of Structural Engineering: Recent submissions
Now showing items 4621-4640 of 10765
-
Out-of-Plane Seismic Performance and Detailing of Brick Veneer Walls
(American Society of Civil Engineers, 2010)The out-of-plane seismic performance of residential brick veneer walls built over wood-frame backup was evaluated as a function of construction detailing. Shake table tests were conducted on a full-scale brick veneer wall ... -
Experimental Study on Full-Scale Light Frame Wood House under Lateral Load
(American Society of Civil Engineers, 2010)This paper explains an experimental study on a full-scale L-shape single story light frame wood house under the uniform lateral load simulated using a gasbag. The study verifies that shear walls are staggered to each other ... -
Structural Behavior of Wood Light-Frame Wall Segments Subjected to In-Plane and Out-of-Plane Forces
(American Society of Civil Engineers, 2010)The tests were performed on 2.44 m by 2.44 m light-frame wall segments, having oriented strand-board sheathing nailed to sawn lumber framing, to determine their structural response to in-plane and out-of-plane forces applied ... -
Impact of Different Earthquake Types on the Statistics of Ductility Demand
(American Society of Civil Engineers, 2010)Probabilistic assessments of the seismic ductility demand for hysteretic bilinear single-degree-of-freedom systems have been reported in the literature. However, a systematic assessment of possible differences in the ... -
Analysis of Reinforced Concrete Shells with Transverse Shear Forces
(American Society of Civil Engineers, 2010)This research investigates the simultaneous effect of in-plane and transverse loads in reinforced concrete shells. The infinitesimal shell element is divided into layers (with triaxial behavior) that are analyzed according ... -
Long-Term Behavior of Composite Beams under Positive and Negative Bending. II: Analytical Study
(American Society of Civil Engineers, 2010)The creep, shrinkage, and cracking of concrete may induce time-dependent changes in the stresses, internal forces, and deflections of steel-concrete composite beams. This paper presents an analytical model to consider these ... -
Alternative Strategies to Enhance the Seismic Performance of Reinforced Concrete-Block Shear Wall Systems
(American Society of Civil Engineers, 2010)In this paper, seven reinforced concrete-block shear walls with aspect ratios of 1.5 and 2.2 (two- and three-storey high) were tested under displacement-controlled cyclic loading. The response of rectangular, flanged, and ... -
Vibration Performance of Lightweight Cold-Formed Steel Floors
(American Society of Civil Engineers, 2010)A study investigating the modal properties and dynamic response of several laboratory-constructed and in situ floors supported with cold-formed steel C-shaped joists for floors was conducted. The tested floors were typical ... -
Seismic Resistance Capacity of High-Rise Buildings Subjected to Long-Period Ground Motions: E-Defense Shaking Table Test
(American Society of Civil Engineers, 2010)A series of large-scale shaking table tests is conducted for a high-rise building structure subjected to long-period ground motions. A test method is developed to preserve the original dimensions of structural members of ... -
Stability Capacity of Metal Plate Connected Wood Truss Assemblies
(American Society of Civil Engineers, 2010)This paper presents the results of an experimental study on the critical buckling load and lateral bracing force of metal plate connected wood truss assemblies. Material property tests—including the modulus of elasticity ... -
Capacity Design of Intermediate Horizontal Boundary Elements of Steel Plate Shear Walls
(American Society of Civil Engineers, 2010)Consistent with capacity design principles and requirements of ductile behavior, the 2005 AISC and 2001 CSA seismic design codes require that the intermediate horizontal boundary elements (HBEs) of steel plate shear walls ... -
Methodology for Wind-Driven Rainwater Intrusion Fragilities for Light-Frame Wood Roof Systems
(American Society of Civil Engineers, 2010)Light-frame wood buildings represent most of residential structures throughout the United States. Approximately half of the U.S. population lives within 50 miles of the coast with many of those dwellings in the Gulf Coast ... -
Three-Dimensional Finite-Element Modeling of Nailed Connections in Wood
(American Society of Civil Engineers, 2010)A three-dimensional nonlinear finite-element model of single nail connection was developed based on transversely isotropic plasticity. In order to have the connection model account for crushing behavior of wood during the ... -
Nonlinear Static Analysis of Structures with Rocking Columns
(American Society of Civil Engineers, 2010)In simple inelastic structures subjected to severe base motions, the maximum acceleration response is bound by the yield strength and is inversely proportional to its mass. It can be demonstrated that a similar effect is ... -
Dynamic Crack Propagations in Prestressed Concrete Sleepers in Railway Track Systems Subjected to Severe Impact Loads
(American Society of Civil Engineers, 2010)Prestressed concrete sleepers (or railroad ties) are the crosstie beam support in railway track systems. They are designed and constructed under flexural constraints in order to carry and transfer the dynamic wheel loads ... -
Reduced Link Sections for Improving the Ductility of Eccentrically Braced Frame Link-to-Column Connections
(American Society of Civil Engineers, 2010)Eccentrically braced frames (EBFs) are desirable seismic load resisting systems as they combine the high elastic stiffness of concentrically braced frames with the ductility and stable energy dissipation of moment resisting ... -
Combined Distortional and Overall Flexural-Torsional Buckling of Cold-Formed Stainless Steel Sections: Design
(American Society of Civil Engineers, 2010)This paper provides a critical summary of the European standards and design methods available for calculating the strength of cold-formed stainless steel compression members. The standards considered (so far mainly applied ... -
Mixed Finite-Element Modeling of Rectangular Concrete-Filled Steel Tube Members and Frames under Static and Dynamic Loads
(American Society of Civil Engineers, 2010)A computational study was conducted to investigate the nonlinear response of composite frames consisting of rectangular concrete-filled steel tube (RCFT) beam-columns and steel framing subjected to static and dynamic loads. ... -
Direct Tension Pullout Bond Test: Experimental Results
(American Society of Civil Engineers, 2010)Results from 50 bond tests conducted using the so-called direct tension pullout specimen type are presented. Anchorages of steel bars with machined deformations were tested so as to enable a targeted study of the effect ... -
Dynamic Identification of a Concrete Bridge with Orthotropic Plate-Type Deck
(American Society of Civil Engineers, 2010)This paper continues a line of research aimed at the development of a dynamically based health condition monitoring of bridge structures in the area of Friuli Venezia Giulia, Italy. One subject of this research program has ...