Journal of Structural Engineering: Recent submissions
Now showing items 1321-1340 of 10765
-
Systemized Structural Predesign Method for Selective Racks
(ASCE, 12/1/2020 )This paper presents a simplified stability-based method for practical structural predesign of down-aisle unbraced frames of selective racks. Given the uniformity of actual racks, only a single upright and its adjoining ... -
Strength of Bolted Lap Joints in Steel Sheets with Small End Distance
(ASCE, 12/1/2020 )The objective of this work is to investigate the shear capacity of small end distance lap joints in sheet steel fastened with a single bolt. For bolted connections in shear, the current American Iron and Steel Institute ... -
Dynamic Characteristics and Responses of Damped Outrigger Tall Buildings Using Negative Stiffness
(ASCE, 12/1/2020 )By introducing negative stiffness devices, this study further improves the maximum achievable damping ratio of conventional damped outrigger (CDO) structures with flexible perimeter columns. Dynamic characteristics of tall ... -
Postfire Performance of Prestressed Concrete Hollow-Core Floor Systems with Edge Beams
(ASCE, 12/1/2020 )This paper presents experimental results and numerical simulation of postfire structural performance of prestressed concrete hollow-core floor slabs with edge beam supports. In total, four tests were carried out, including ... -
Full-Scale Experimental Testing and Postfracture Simulations of Cast-Steel Yielding Connectors
(ASCE, 12/1/2020 )The cast-steel yielding connector (YC) is a yielding fuse device designed to dissipate earthquake energy through inelastic deformations in specially designed distributed yielding regions, while ensuring primarily elastic ... -
Topology-Finding of Tensegrity Structures Considering Global Stability Condition
(ASCE, 12/1/2020 )This study proposes a general framework for topology-finding or topology optimization of tensegrity structures. The existing topology-finding formulation of tensegrity structures based on mixed-integer linear programming ... -
Experimental Investigation of Axial Load and Detailing Effects on the Inelastic Response of Reinforced-Concrete Masonry Structural Walls with Boundary Elements
(ASCE, 12/1/2020 )In typical wall load-bearing reinforced-masonry (RM) buildings, the lateral and vertical forces are resisted by rectangular shear walls. Thus, the walls are subjected to high vertical forces from gravity loads that are ... -
Collapse Simulations of Steel-Concrete Composite Floors under Column Loss Scenarios
(ASCE, 12/1/2020 )Characterizing structural resiliency after severe damage to a few load-carrying members is challenging. Engineers use various computational approaches to assess the vulnerability of structures and to evaluate the parameters ... -
Effects of Vertical Ground Motion on Seismic Performance of Reinforced Concrete Flat-Plate Buildings
(ASCE, 12/1/2020 )Nonlinear time-history analyses are conducted on a flat-plate building to explore the damaging effects of vertical ground acceleration on punching shear failure of slab–column connections, which have been exposed by field ... -
Connection and System Ductility Relationship for Braced Timber Frames
(ASCE, 12/1/2020 )Braced timber frames (BTFs) are an efficient lateral load-resisting system for wind and seismic loads. This paper derived a relationship between the connection ductility and the system ductility of concentric BTFs based ... -
RC Wall Plastic Hinge Out-of-Plane Buckling: Analysis Using the Nonlinear Beam-Truss Model
(ASCE, 12/1/2020 )The beam-truss model (BTM), developed for the nonlinear cyclic analysis of reinforced concrete components including softening, is extended to compute the out-of-plane buckling observed in plastic hinges of various slender ... -
Buffeting Analysis of Long-Span Bridges under Typhoon Winds with Time-Varying Spectra and Coherences
(ASCE, 12/1/2020 )Typhoon winds near the external eye wall of a strong typhoon are extremely nonstationary and disastrous due to its vortex and convective origin as well as its high wind speeds. However, typhoon-induced nonstationary responses ... -
Seismic Fragility Estimates for Cross-Laminated Timber Platform Building
(ASCE, 12/1/2020 )Cross-laminated timber (CLT) has been gaining popularity also in seismic regions, because of its low carbon footprint and potential cost-competitiveness with concrete and steel construction. Recent effort has focused on ... -
Simplified Dynamic Assessment for Reinforced-Concrete Structures Subject to Column Removal Scenarios
(ASCE, 12/1/2020 )A simple yet effective method for dynamic assessment of building structures subject to a sudden column removal is presented. An equivalent single-degree-of-freedom (SDOF) dynamic model to predict the realistic dynamic ... -
Shaking Table Test on 1/2-Scale Model of Column-and-Tie Timber Structure Filled with Wooden Walls
(ASCE, 12/1/2020 )To study the influence of wooden walls on the seismic performance of traditional Chinese column-and-tie timber structures, two 1/2-scale two-story and two-span timber structure models were fabricated. The infill wall was ... -
Regional Seismic Risk Assessment of Infrastructure Systems through Machine Learning: Active Learning Approach
(ASCE, 12/1/2020 )Regional seismic risk assessment involves many infrastructure systems, and it is computationally intensive to conduct an individual simulation of each system. This paper suggests an approach using active learning to select ... -
Lateral Torsional Buckling of Welded Stainless-Steel I-Profile Beams: Design and Reliability
(ASCE, 12/1/2020 )In this paper, a geometrically and materially nonlinear numerical model using ANSYS is validated against 13 lateral torsional buckling (LTB) experiments as well as experiments from the literature. A parametric study ... -
Seismic Collapse Assessment of Composite Plate Shear Walls
(ASCE, 12/1/2020 )Collapse evaluation of composite plate shear walls (C-PSWs) under seismic loading requires a reliable analytical model that can accurately capture deterioration in the strength and stiffness of the system. In this study, ... -
Stub Column Behavior of Cold-Formed High-Strength Steel Circular Hollow Sections under Compression
(ASCE, 12/1/2020 )This paper describes an experimental and numerical investigation on the stub column behavior of cold-formed high-strength steel (HSS) circular hollow sections (CHSs). A total of 16 stub column specimens fabricated from ... -
Size Effect on Nominal Strength of Lightweight and Normal Concrete-Filled Steel Tube Columns under Axial Compression: Mesoscale Simulations
(ASCE, 12/1/2020 )With the devolvement of large-span structures and super high-rise buildings, lightweight aggregate concrete (LWAC) materials have been widely utilized. The main content of this work is to explore the failure and size effect ...