Journal of Composites for Construction: Recent submissions
Now showing items 1761-1780 of 2137
-
Residual Performance of FRP-Retrofitted RC Columns after Being Subjected to Cyclic Loading Damage
(American Society of Civil Engineers, 2006)Numerous recent research findings evidenced the success of retrofitting existing RC columns using fiber-reinforced plastic (FRP) jacketing. However, little is known about the residual performance of FRP-retrofitted RC ... -
Comparison of Roles of FRP Sheets, Stirrups, and Steel Fibers in Confining Bond Critical Regions
(American Society of Civil Engineers, 2006)Based on experimental data of tension lap splices confined with fiber reinforced polymer (FRP) sheets in normal and high strength concrete (HSC) specimens, a new FRP confinement parameter, -
Splicing of Precast Concrete-Filled FRP Tubes
(American Society of Civil Engineers, 2006)This paper reports on a feasibility study of splicing techniques for precast concrete-filled fiber-reinforced polymer (FRP) tubes (CFFT). A total of four spliced beams were tested. Three were internally spliced using grouted ... -
Evaluation of Bending Strength of RC Beams Strengthened with FRP Sheets
(American Society of Civil Engineers, 2006)This paper deals with reinforced concrete beams strengthened by means of externally bonded fiber-reinforced polymer (FRP) sheets. The scope of the work is to discuss and compare an exact and an approximate approach to the ... -
Effect of Contact Pressure on Bond Strength of Fiber-Reinforced Polymer to Concrete
(American Society of Civil Engineers, 2006)In this technical note, the importance of contact pressure ( -
Tensile Lap Splicing of Bundled CFRP Reinforcing Bars in Concrete
(American Society of Civil Engineers, 2006)In the case of heavily reinforced concrete structural members, bundled bars are required rather than spaced bars. The use of spliced bundled bars is necessary when available bar lengths are limited. No design recommendations ... -
Editor’s Note
(American Society of Civil Engineers, 2006) -
Structural Retrofitting of Deteriorated Concrete Lighting Poles Using FRP Sheets in Wet Layup—Field Application
(American Society of Civil Engineers, 2006)This paper investigates the structural retrofit of deteriorated reinforced concrete lighting poles using wet layup of fiber reinforced polymer (FRP) sheets. The study comprised of four full-scale Class B damaged poles and ... -
Effect of Fiber-Reinforced Polymer Wraps on Corrosion Activity and Concrete Cracking in Chloride-Contaminated Concrete Cylinders
(American Society of Civil Engineers, 2006)This paper presents the results of an experimental study designed to investigate the effect of fiber-reinforced polymer (FRP) wraps on corrosion activity and concrete cracking in chloride-contaminated concrete cylinders. ... -
Response Prediction of RC Beams Externally Bonded with Steel-Reinforced Polymers
(American Society of Civil Engineers, 2006)This paper deals with an innovative technique for strengthening reinforced concrete (RC) structures using steel-reinforced polymer (SRP) materials. The results of an experimental campaign using RC beams strengthened in ... -
Critical Review of Deflection Formulas for FRP-RC Members
(American Society of Civil Engineers, 2006)The design of fiber-reinforced polymer reinforced concrete (FRP-RC) is typically governed by serviceability limit state requirements rather than ultimate limit state requirements as conventional reinforced concrete is. ... -
Experimental In-Plane Behavior of Tuff Masonry Strengthened with Cementitious Matrix–Grid Composites
(American Society of Civil Engineers, 2006)Tuff buildings are a significant part of the Mediterranean area and are to be preserved from a structural viewpoint especially in seismic areas. Over the past few decades, the interest in strengthening of historical tuff ... -
Empirical Approach for Determining Ultimate FRP Strain in FRP-Strengthened Concrete Beams
(American Society of Civil Engineers, 2006)The flexural capacity of concrete beams can be efficiently and effectively improved through bonding fiber-reinforced plastic (FRP) plates to the tensile side. Failure of the strengthened member often occurs through debonding ... -
Rehabilitation of Masonry Walls Using Unobtrusive FRP Techniques for Enhanced Out-of-Plane Seismic Resistance
(American Society of Civil Engineers, 2006)Earthquake damage to unreinforced masonry buildings has shown the vulnerability of perimeter walls to out-of-plane failure. This paper describes a study that was carried out to develop and test innovative fiber reinforced ... -
Dynamic Characteristics and Effective Stiffness Properties of Honeycomb Composite Sandwich Structures for Highway Bridge Applications
(American Society of Civil Engineers, 2006)In this paper, a combined analytical and experimental study of dynamic characteristics of honeycomb composite sandwich structures in bridge systems is presented, and a relatively simple and reliable dynamic experimental ... -
Short and Medium Term Durability Evaluation of FRP-Confined Circular Concrete
(American Society of Civil Engineers, 2006)Evaluation of environmental durability of concrete circular specimens strengthened using externally applied fiber-reinforced-polymer (FRP) composites for confinement reinforcement was studied. FRP-confined concrete cylinder ... -
Flexural Load Testing of Concrete-Filled FRP Tubes with Longitudinal Steel and FRP Rebar
(American Society of Civil Engineers, 2006)The flexural performance of reinforced concrete-filled glass-fiber reinforced polymer (GFRP) tubes (CFFTs) has been investigated using seven specimens, -
Debonding Failures of RC Beams Strengthened with Near Surface Mounted CFRP Strips
(American Society of Civil Engineers, 2006)This paper presents the results of a series of tests conducted on reinforced concrete (RC) beams strengthened in flexure with near surface mounted (NSM) carbon fiber-reinforced polymer (CFRP) strips. As the main focus of ... -
Composite T-Beams Using Reduced-Scale Rectangular FRP Tubes and Concrete Slabs
(American Society of Civil Engineers, 2006)A composite system consisting of rectangular glass fiber reinforced polymer (GFRP) tubes connected to concrete slabs, using GFRP dowels has been developed. Seven beam specimens have been tested, including hollow and ... -
Double-Layer Prefabricated FRP Grids for Rapid Bridge Deck Construction: Case Study
(American Society of Civil Engineers, 2006)This paper presents a case study of prefabricated double-layer pultruded fiber-reinforced polymer (FRP) grids for bridge deck construction. These grids were used to reinforce a