Journal of Composites for Construction: Recent submissions
Now showing items 1621-1640 of 2137
-
Experimental Study of Interfacial Shear Stresses in FRP-Strengthened RC Beams
(American Society of Civil Engineers, 2008)This paper presents the results of an experimental study on the distribution of shear stresses along the interface between concrete and the carbon fiber-reinforced polymer (FRP) in 29 plate-strengthened beams, where the ... -
Bond Tests of Short NSM-FRP and Steel Bar Anchorages
(American Society of Civil Engineers, 2008)Performance of near-surface mounted (NSM) bars as additional reinforcement in strengthening of existing reinforced-concrete construction largely depends on the development capacity of the bar inside the groove. This is ... -
Shear Strengthening of T Cross Section Reinforced Concrete Beams by Near-Surface Mounted Technique
(American Society of Civil Engineers, 2008)With the purpose of evaluating the influence of both the percentage and inclination of the carbon fiber-reinforced polymer (CFRP) laminates on the effectiveness of the near-surface mounted technique for the shear strengthening ... -
Analysis of the Flexural Behavior of Partially Bonded FRP Strengthened Concrete Beams
(American Society of Civil Engineers, 2008)An investigation was conducted on the flexural behavior of partially bonded fiber-reinforced polymer (FRP) strengthened concrete beams focusing on the improvement of ductility. An analytical model was developed based on ... -
Bond Enhancement for FRP Pile Repair in Tidal Waters
(American Society of Civil Engineers, 2008)Vacuum bagging and pressure bagging are established techniques used by the composites industry for fabricating components. This paper describes a study that explored the adaptation of these techniques for improving the ... -
Flexure of Two-Way Slabs Strengthened with Prestressed or Nonprestressed CFRP Sheets
(American Society of Civil Engineers, 2008)This paper presents a study on the flexural behavior of two-way reinforced concrete slabs externally strengthened with prestressed or nonprestressed carbon fiber-reinforced polymer (CFRP) sheets. Four large-scale flat plate slabs -
Deflection Response of Glass Fiber-Reinforced Pultruded Components in Hot Weather Climates
(American Society of Civil Engineers, 2008)Presented in this paper are the experimental results pertaining to the deflection response of E-glass/polyester pultruded structural elements when subjected to bending and temperature profiles comparable to those encountered ... -
Light-Weight Fiber-Reinforced Polymer Composite Deck Panels for Extreme Applications
(American Society of Civil Engineers, 2008)Currently within the military there is a need for a universal light-weight bridge deck system capable of supporting extreme loads over a wide temperature range. This research presents the development, testing, and analysis ... -
Fatigue Behavior of Externally Strengthened Concrete Beams with Fiber-Reinforced Polymers: State of the Art
(American Society of Civil Engineers, 2008)This paper presents the recent progress and achievement in the application of fiber-reinforced polymers (FRP) on strengthening reinforced/prestressed concrete beams subjected to fatigue loading. Although the performance ... -
Performance of Mechanically Fastened FRP Strengthened Concrete Beams in Flexure
(American Society of Civil Engineers, 2008)The use of adhesively bonded fiber-reinforced polymer (FRP) materials has become widely accepted for use in flexural strengthening applications; however, the method of attachment presents drawbacks in application. These ... -
Quasi-Balanced Failure Approach for Evaluating Moment Capacity of FRP Underreinforced Concrete Beams
(American Society of Civil Engineers, 2008)Failure of concrete beam sections underreinforced with fiber-reinforced polymer (FRP) is initiated by FRP rupture before concrete crushing. In such a case, the typical rectangular stress block based on the balanced failure ... -
Development and Evaluation of an Adhesively Bonded Panel-to-Panel Joint for a FRP Bridge Deck System
(American Society of Civil Engineers, 2008)A fiber-reinforced polymer (FRP) composite cellular deck system was used to rehabilitate a historical cast iron thru-truss structure (Hawthorne St. Bridge in Covington, Va.). The most important characteristic of this ... -
Fatigue Life Assessment and Static Testing of Structural GFRP Tubes Based on Coupon Tests
(American Society of Civil Engineers, 2008)Fiber-reinforced polymer (FRP) hollow tubes are used in structural applications, such as utility poles and pipelines. Concrete-filled FRP tubes (CFFTs) are also used as piles and bridge piers. Applications such as poles ... -
Evaluating and Proposing Models of Predicting IC Debonding Failure
(American Society of Civil Engineers, 2008)Debonding failure due to intermediate crack-induced (IC) fracture is one of the most dominant failure modes associated with the fiber-reinforced polymer (FRP) bonding technique. To date, extensive efforts have been paid ... -
Ductility and Cracking Behavior of Prestressed Concrete Beams Strengthened with Prestressed CFRP Sheets
(American Society of Civil Engineers, 2008)This paper investigates the flexure of prestressed concrete beams strengthened with prestressed carbon fiber-reinforced polymer (CFRP) sheets, focusing on ductility and cracking behavior. Structural ductility of a beam ... -
Hybrid Bonding of FRP to Reinforced Concrete Structures
(American Society of Civil Engineers, 2008)The adhesive attachment of fiber-reinforced polymers (FRP) laminate to the external face of reinforced concrete structures is currently one of the most popular and effective methods for retrofitting and strengthening ... -
Does the Use of FRP Reinforcement Change the One-Way Shear Behavior of Reinforced Concrete Slabs?
(American Society of Civil Engineers, 2008)For members with no transverse reinforcement, numerous models have been proposed for determining shear capacity, most often based on a statistical curve fit to experimental beam test results. The shear provisions of the ... -
Experimental Study on Bond Behavior between Concrete and FRP Reinforcement
(American Society of Civil Engineers, 2008)Bonding between fiber-reinforced polymer (FRP) sheets and concrete supports is essential in shear and flexural applications for transfer of stress between concrete structure and reinforcement. This paper aims at better ... -
IC Debonding of FRP NSM and EB Retrofitted Concrete: Plate and Cover Interaction Tests
(American Society of Civil Engineers, 2008)The use of fiber-reinforced polymer (FRP) externally bonded (EB) plates is widely accepted as an efficient and unobtrusive retrofitting technique. FRP near-surface mounted plates are now also gradually gaining acceptance ... -
Assessing the Efficiency of CFRP Discrete Confinement Systems for Concrete Cylinders
(American Society of Civil Engineers, 2008)Concrete columns requiring strengthening intervention always contain a certain percentage of steel hoops. Applying strips of wet layup carbon fiber-reinforced polymer (CFRP) sheets inbetween the existent steel hoops might, ...