• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Biaxial Residual Stress Mapping for a Dissimilar Metal Welded Nozzle

    Thumbnail
    View/Open
    pvt_138_01_011404.pdf (4.289Mb)
    Date
    2016
    Author
    Hill, Michael R.
    Olson, Mitchell D.
    DeWald, Adrian T.
    Metadata
    Show full item record
    Abstract
    This paper describes a sequence of residual stress measurements made to determine a twodimensional map of biaxial residual stress in a nozzle mockup having two welds, one a dissimilar metal (DM) weld and the other a stainless steel (SS) weld. The mockup is cylindrical, designed to represent a pressurizer surge nozzle of a nuclear pressurized water reactor (PWR), and was fabricated as part of a weld residual stress measurement and finiteelement (FE) modeling roundrobin exercise. The mockup has a nickel alloy DM weld joining an SS safe end to a lowalloy steel cylinder and stiffening ring, as well as an SS weld joining the safe end to a section of SS pipe. The biaxial mapping experiments follow an approach described earlier, in PVP201278885 and PVP201397246, and comprise a series of experimental steps and a computation to determine a twoآ dimensional map of biaxial (axial and hoop) residual stress near the SS and DM welds. Specifically, the biaxial stresses are a combination of a contour measurement of hoop stress in the cylinder, slitting measurements of axial stress in thin slices removed from the cylinder wall, and a computation that determines the axial stress induced by measured hoop stress. At the DM weld, hoop stress is tensile near the OD (240 MPa) and compressive at the ID (−320 MPa), and axial stress is tensile near the OD (370 MPa) and compressive near the midthickness (−230 MPa) and ID (−250 MPa). At the SS weld, hoop stress is tensile near the OD (330 MPa) and compressive near the ID (−210 MPa), and axial stress is tensile at the OD (220 MPa) and compressive near midthickness (−225 MPa) and ID (−30 MPa). The measured stresses are found to be consistent with earlier work in similar configurations.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/162327
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV