Show simple item record

dc.contributor.authorYamashita, Takuya
dc.contributor.authorNagae, Yuji
dc.contributor.authorSatoh, Kenichiro
dc.contributor.authorYamamoto, Kenji
dc.date.accessioned2017-05-09T01:32:38Z
dc.date.available2017-05-09T01:32:38Z
dc.date.issued2016
dc.identifier.issn0094-9930
dc.identifier.otherpvt_138_02_024501.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/162325
dc.description.abstractType 316 stainless steel with lowcarbon and mediumnitrogen contents called 316FR stainless steel is a candidate structural material for reactor vessels and internals of futuregeneration fast breeder reactors (FBRs). The reactor vessel cannot be manufactured from rolled or forged steel, but can be built at reasonable cost by welding rolled steel plates. In this manufacture approach, the reliability of the welded joint must be indicated. Two types of filler metals are candidates for 316FR welded joints: types 316FR and 1682 filler metals. The chemical composition of type 316FR filler metal is close to that of the stainless steel; type 1682 filler metal contains lower amounts of Ni, Cr, and Mo than that of the stainless steel. This study evaluated the need to consider the welded joint strength reduction factors in 316FR welded joints under design of futuregeneration FBRs. To this end, the tensile and creep strengths of types 316FR and 1682 weld metals were measured, and the effect of خ´ferrite in weld metals was evaluated in creep strength tests of 316FR welded joints. In tensile and creep strengths of 316FR welded joints welded by both metal types, the welded joint strength reduction factors were immaterial. The creep strength of 316FR welded joints was negligibly affected by خ´ferrite levels from 4.1 to 7.0 ferrite number (FN) in the Welding Research Council1992 diagram. Furthermore, the tensile and creep strengths of 316FR welded joints by two methods (gas tungsten arc welding (GTAW) and shielded metal arc welding (SMAW)) were the same. Therefore, the tensile and creep strengths of 316FR welded joints in above condition are ensured the reliability of similar to 316FR stainless steels.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStrength of 316FR Joints Welded by Type 316FR/16 8 2 Filler Metals
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4031444
dc.journal.fristpage24501
dc.journal.lastpage24501
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2016:;volume( 138 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record