• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Strength of 316FR Joints Welded by Type 316FR/16 8 2 Filler Metals

    Thumbnail
    View/Open
    pvt_138_02_024501.pdf (1.174Mb)
    Date
    2016
    Author
    Yamashita, Takuya
    Nagae, Yuji
    Satoh, Kenichiro
    Yamamoto, Kenji
    Metadata
    Show full item record
    Abstract
    Type 316 stainless steel with lowcarbon and mediumnitrogen contents called 316FR stainless steel is a candidate structural material for reactor vessels and internals of futuregeneration fast breeder reactors (FBRs). The reactor vessel cannot be manufactured from rolled or forged steel, but can be built at reasonable cost by welding rolled steel plates. In this manufacture approach, the reliability of the welded joint must be indicated. Two types of filler metals are candidates for 316FR welded joints: types 316FR and 1682 filler metals. The chemical composition of type 316FR filler metal is close to that of the stainless steel; type 1682 filler metal contains lower amounts of Ni, Cr, and Mo than that of the stainless steel. This study evaluated the need to consider the welded joint strength reduction factors in 316FR welded joints under design of futuregeneration FBRs. To this end, the tensile and creep strengths of types 316FR and 1682 weld metals were measured, and the effect of خ´ferrite in weld metals was evaluated in creep strength tests of 316FR welded joints. In tensile and creep strengths of 316FR welded joints welded by both metal types, the welded joint strength reduction factors were immaterial. The creep strength of 316FR welded joints was negligibly affected by خ´ferrite levels from 4.1 to 7.0 ferrite number (FN) in the Welding Research Council1992 diagram. Furthermore, the tensile and creep strengths of 316FR welded joints by two methods (gas tungsten arc welding (GTAW) and shielded metal arc welding (SMAW)) were the same. Therefore, the tensile and creep strengths of 316FR welded joints in above condition are ensured the reliability of similar to 316FR stainless steels.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/162325
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV