Show simple item record

dc.contributor.authorMahamudur Rahman, Md
dc.contributor.authorHu, Han
dc.contributor.authorShabgard, Hamidreza
dc.contributor.authorBoettcher, Philipp
dc.contributor.authorSun, Ying
dc.contributor.authorMcCarthy, Matthew
dc.date.accessioned2017-05-09T01:30:26Z
dc.date.available2017-05-09T01:30:26Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_07_072301.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161615
dc.description.abstractThe inward melting and solidification of phasechange materials (PCM) within millimeterscale cylindrical enclosures have been experimentally characterized in this work. The effects of cylinder size, thermal loading, and concentration of highconductivity additives were investigated under constant temperature boundary conditions. Using a custombuilt apparatus with fast response, freezing and melting have been measured for time periods as short as 15 s and 33 s, respectively. The enhancement of PCM thermal conductivity using exfoliated graphene nanoplatelets (xGnPs) has also been measured, showing a greater than 3أ— increase for a concentration of 6 wt.%. Reductions in the total melting and freezing times of up to 66% and 55%, respectively, have been achieved using xGnP concentrations of only 4.5 wt.%. It is shown that the phasechange dynamics of pure and enhanced PCM are well predicted using a simple conductiononly model, demonstrating the validity of approximating enhanced PCM with low additive loadings as homogenous materials with isotropic properties. While general consistency between the measurements and model is seen, the effect of additives on heat transfer rate during the initial stages of freezing and melting is lower than expected, particularly for the smaller cylinder sizes of 6 mm. These results suggest that the thermal resistance of the PCM is not the limiting factor dictating the speed of the solid–liquid interface during these initial stages.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Characterization of Inward Freezing and Melting of Additive Enhanced Phase Change Materials Within Millimeter Scale Cylindrical Enclosures
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4033007
dc.journal.fristpage72301
dc.journal.lastpage72301
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record