• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Experimental Characterization of Inward Freezing and Melting of Additive Enhanced Phase Change Materials Within Millimeter Scale Cylindrical Enclosures

    Thumbnail
    View/Open
    ht_138_07_072301.pdf (3.199Mb)
    Date
    2016
    Author
    Mahamudur Rahman, Md
    Hu, Han
    Shabgard, Hamidreza
    Boettcher, Philipp
    Sun, Ying
    McCarthy, Matthew
    Metadata
    Show full item record
    Abstract
    The inward melting and solidification of phasechange materials (PCM) within millimeterscale cylindrical enclosures have been experimentally characterized in this work. The effects of cylinder size, thermal loading, and concentration of highconductivity additives were investigated under constant temperature boundary conditions. Using a custombuilt apparatus with fast response, freezing and melting have been measured for time periods as short as 15 s and 33 s, respectively. The enhancement of PCM thermal conductivity using exfoliated graphene nanoplatelets (xGnPs) has also been measured, showing a greater than 3أ— increase for a concentration of 6 wt.%. Reductions in the total melting and freezing times of up to 66% and 55%, respectively, have been achieved using xGnP concentrations of only 4.5 wt.%. It is shown that the phasechange dynamics of pure and enhanced PCM are well predicted using a simple conductiononly model, demonstrating the validity of approximating enhanced PCM with low additive loadings as homogenous materials with isotropic properties. While general consistency between the measurements and model is seen, the effect of additives on heat transfer rate during the initial stages of freezing and melting is lower than expected, particularly for the smaller cylinder sizes of 6 mm. These results suggest that the thermal resistance of the PCM is not the limiting factor dictating the speed of the solid–liquid interface during these initial stages.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/161615
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV