Show simple item record

dc.contributor.authorOngkodjojo Ong, Andojo
dc.contributor.authorAbramson, Alexis R.
dc.contributor.authorTien, Norman C.
dc.date.accessioned2017-05-09T01:09:27Z
dc.date.available2017-05-09T01:09:27Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_06_061703.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155276
dc.description.abstractThis work demonstrates an innovative microfabricated aircooling technology that employs an electrohydrodynamic (EHD) corona discharge (i.e., ionic wind pump) for electronics cooling applications. A single, microfabricated ionic wind pump element consists of two parallel collecting electrodes between which a single emitting tip is positioned. A grid structure on the collector electrodes can enhance the overall heattransfer coefficient and facilitate an IC compatible batch process. The optimized devices studied exhibit an overall device area of 5.4 mm أ— 3.6 mm, an emittertocollector gap of ∼0.5 mm, and an emitter curvature radius of ∼12.5 خ¼m. The manufacturing process developed for the device uses glass wafers, a single maskbased photolithography process, and a lowcost copperbased electroplating process. Various design configurations were explored and modeled computationally to investigate their influence on the cooling phenomenon. The single devices provide a high heattransfer coefficient of up to ∼3200 W/m2 K and a coefficient of performance (COP) of up to ∼47. The COP was obtained by dividing the heat removal enhancement, خ”Q by the power consumed by the ionic wind pump device. A maximum applied voltage of 1.9 kV, which is equivalent to approximately 38 mW of power input, is required for operation, which is significantly lower than the power required for the previously reported devices. Furthermore, the microfabricated single device exhibits a flexible and small form factor, no noise generation, high efficiency, large heat removal over a small dimension and at low power, and high reliability (no moving parts); these are characteristics required by the semiconductor industry for next generation thermal management solutions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleElectrohydrodynamic Microfabricated Ionic Wind Pumps for Thermal Management Applications
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue6
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4026807
dc.journal.fristpage61703
dc.journal.lastpage61703
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record