• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Electrohydrodynamic Microfabricated Ionic Wind Pumps for Thermal Management Applications

    Thumbnail
    View/Open
    ht_136_06_061703.pdf (1.634Mb)
    Date
    2014
    Author
    Ongkodjojo Ong, Andojo
    Abramson, Alexis R.
    Tien, Norman C.
    Metadata
    Show full item record
    Abstract
    This work demonstrates an innovative microfabricated aircooling technology that employs an electrohydrodynamic (EHD) corona discharge (i.e., ionic wind pump) for electronics cooling applications. A single, microfabricated ionic wind pump element consists of two parallel collecting electrodes between which a single emitting tip is positioned. A grid structure on the collector electrodes can enhance the overall heattransfer coefficient and facilitate an IC compatible batch process. The optimized devices studied exhibit an overall device area of 5.4 mm أ— 3.6 mm, an emittertocollector gap of ∼0.5 mm, and an emitter curvature radius of ∼12.5 خ¼m. The manufacturing process developed for the device uses glass wafers, a single maskbased photolithography process, and a lowcost copperbased electroplating process. Various design configurations were explored and modeled computationally to investigate their influence on the cooling phenomenon. The single devices provide a high heattransfer coefficient of up to ∼3200 W/m2 K and a coefficient of performance (COP) of up to ∼47. The COP was obtained by dividing the heat removal enhancement, خ”Q by the power consumed by the ionic wind pump device. A maximum applied voltage of 1.9 kV, which is equivalent to approximately 38 mW of power input, is required for operation, which is significantly lower than the power required for the previously reported devices. Furthermore, the microfabricated single device exhibits a flexible and small form factor, no noise generation, high efficiency, large heat removal over a small dimension and at low power, and high reliability (no moving parts); these are characteristics required by the semiconductor industry for next generation thermal management solutions.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/155276
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV