Show simple item record

dc.contributor.authorMazhar, H.
dc.contributor.authorEwing, D.
dc.contributor.authorCotton, J. S.
dc.contributor.authorChing, C. Y.
dc.date.accessioned2017-05-09T01:09:22Z
dc.date.available2017-05-09T01:09:22Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_04_043001.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155244
dc.description.abstractThe distributions of the mass transfer coefficient in horizontal 90 deg bends were measured under a range of two phase annular flow conditions. A dissolving wall technique at a high Schmidt number (Sc = 1280) is used for the measurements. The maximum mass transfer occurred on the centerline of the bend outer wall at an angle of approximately 50 deg from the bend inlet under all tested conditions. The area of maximum mass transfer rate was found to span approximately 30 deg in the circumferential direction. A second region of enhanced mass transfer occurred on the latter part of the bend with a local maximum occurring slightly off the bend centerline in some cases. Changing the air and water superficial velocities (Jv = 22–30 m/s, JL = 0.17–0.41 m/s) showed that the air velocity had a larger effect on the mass transfer rates than the water velocity; however, the effect of the water velocity on the mass transfer was not insignificant.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMass Transfer in Single Bends Under Annular Two Phase Flow Conditions
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue4
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4026009
dc.journal.fristpage43001
dc.journal.lastpage43001
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record