• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Mass Transfer in Single Bends Under Annular Two Phase Flow Conditions

    Thumbnail
    View/Open
    ht_136_04_043001.pdf (1.898Mb)
    Date
    2014
    Author
    Mazhar, H.
    Ewing, D.
    Cotton, J. S.
    Ching, C. Y.
    Metadata
    Show full item record
    Abstract
    The distributions of the mass transfer coefficient in horizontal 90 deg bends were measured under a range of two phase annular flow conditions. A dissolving wall technique at a high Schmidt number (Sc = 1280) is used for the measurements. The maximum mass transfer occurred on the centerline of the bend outer wall at an angle of approximately 50 deg from the bend inlet under all tested conditions. The area of maximum mass transfer rate was found to span approximately 30 deg in the circumferential direction. A second region of enhanced mass transfer occurred on the latter part of the bend with a local maximum occurring slightly off the bend centerline in some cases. Changing the air and water superficial velocities (Jv = 22–30 m/s, JL = 0.17–0.41 m/s) showed that the air velocity had a larger effect on the mass transfer rates than the water velocity; however, the effect of the water velocity on the mass transfer was not insignificant.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/155244
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV