• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Three-Dimensional Fracture Analysis of Circumferentially Cracked Boiler Tubes

    Thumbnail
    View/Open
    JPVTAS-28567#031202_1.pdf (1.521Mb)
    Date
    2012
    Author
    E. Citirik
    Metadata
    Show full item record
    Abstract
    A comprehensive methodology is developed to understand and characterize the fracture behavior of circumferentially cracked boiler tubes in this study. Weld overlay is applied on the coal-fired boiler tubes in order to prevent the degradation of corrosive and erosive environment that the boiler tubes are exposed to in the power plants. Finite element modeling and analysis are employed for all of the computations including steady-state and transient stress intensity factor (SIF) calculations in this study. Circumferential cracking has been one of the failure modes in waterwall boiler tubes, which results in high maintenance and replacement costs. Thermomechanical stresses and corrosive environment are basically the two remarkable contributors that bring about this failure mode. The former one is investigated and quantified in this study in order to explain the fracture behavior of weld overlay coatings during the power plant operation. Periodic soot blowing operations cause cyclic transient thermomechanical stresses on the weld overlay coating that results in crack propagation and fatigue failure. Three-dimensional fracture analysis of circumferentially cracked boiler tubes is examined using enriched finite element method in this study. Transient temperatures and thermomechanical stresses are computed using ANSYS for five different periodic crack spacing values (h), which are 2, 4, 6, 10, and 20 mm in the axial direction. 3D fracture analysis was performed, and stress intensity factors were computed using FRAC3D , which is Finite Element Analysis (FEA) software developed at Lehigh University. The maximum stress intensity factor is obtained at the deepest penetration of the crack in the model which has the largest periodic axial crack spacing, h = 20 mm. The stress intensity factors due to welding residuals decrease as the axial crack spacing, h, decreases. The FEA methodology developed in this research would provide the engineers with the ability to understand the fracture problem and predict component life and improve the reliability of the weld overlay coated boiler tubes utilized in the power plants.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/150112
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV