Show simple item record

dc.contributor.authorOwen Sengstock
dc.contributor.authorKamel Hooman
dc.date.accessioned2017-05-09T00:51:56Z
dc.date.available2017-05-09T00:51:56Z
dc.date.copyrightNovember, 2012
dc.date.issued2012
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-926057#114505_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/149327
dc.description.abstract3D numerical results are presented to compare the heat transfer augmentation from a plate by using pin fins and metal foams. It is observed that maximizing the inlet velocity and pores per inch maximizes the overall heat transfer rate. The thickness of the foam layer has minimal effect on overall rates of heat transfer, but great effect on the maximum plate temperature. It has been shown that an optimum thickness exists which minimizes the hot spot temperature. Hot spots are generally located in the corners where velocities are the lowest. While the pressure drop remains almost unaltered, the heat transfer increases by 146% and 12% compared with a smooth channel and the optimal pin-fin data available in the literature, respectively. Interestingly, the additional mass of the foams, to achieve this performance, is approximately one-quarter of the best pin-fin sink quoted above.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHeat Transfer Enhancement From a Blade Tip-Cap Using Metal Foams
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4007134
dc.journal.fristpage114505
dc.identifier.eissn1528-8943
dc.keywordsHeat transfer
dc.keywordsChannels (Hydraulic engineering)
dc.keywordsBlades
dc.keywordsMetal foams
dc.keywordsPressure drop
dc.keywordsThickness
dc.keywordsTemperature
dc.keywordsFins AND Foams (Chemistry)
dc.treeJournal of Heat Transfer:;2012:;volume( 134 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record